qoistoochee128

Mini drone kit with flight controller, motor, propellers, frame and batteries

STEVAL-DRONE01

Overview

The STEVAL-DRONE01 mini drone kit features the high performance STEVAL-FCU001V1 flight controller unit, as well as the motors, propellers, plastic frame and battery you need to assemble your own mini-drone.

The flight controller unit runs the firmware (STSW-FCU001) to control the speed of each connected motor and to stabilize the drone. To achieve this, the STM32F4 microcontroller hosted on the board analyses data from the accelerometer and gyroscope sensors (LSM6DSL and iNEMO 6DoF inertial measurement unit) to provide highly accurate stability and control.
The FCU board includes a Bluetooth Low Energy SPBTLE-RF module, so you can turn your smartphone running a dedicated App into a remote control unit.

Main features

Drone Kit based on the STEVAL-FCU001V1 compact flight controller unit
Four motors: 85x20 mm, 3.7 V
Two clockwise and two counterclockwise 65 mm propellers, plus a couple of spares
LiPo 3.7 V / 600 mAh battery with a maximum discharge current of 30 C
3D plastic mechanical frame including propeller guards for safety
WEEE and RoHS compliant
Compliant with Directive 2006/66/EC

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-19 14:52:21

Please tell me about the output voltage of the op amp.
Today I am learning about the output of the MC33172 op amp. In the open loop state, the positive power supply is 15V and the negative power supply is -15V. The input pins are floating. VOUT1= 14.98 V
Is the operating system used by PPC2003 ce5 or 6?
I want to install ce5, can anyone give me an address where I can download it?
See Beaglebone Run Series 2——See Beaglebone Run Benchmark
Leave a hole first
Problems with thyristor voltage regulation and temperature control
The temperature is measured by thermocouple, PID is adjusted by single chip microcomputer, and the solid state relay is triggered to realize linear temperature rise. However, when the grid voltage cha
Writing data to PCF8563, the program fails, please help me
#include msp430x54x.h #define SDA_1 P3OUT |= BIT7 //SDA = 1 #define SDA_0 P3OUT =~ BIT7 //SDA = 0 #define SCL_1 P5OUT |= BIT4 //SCL = 1 #define SCL_0 P5OUT =~ BIT4 //SCL = 0 #define DIR_IN P3DIR =~ BI
I would like to know the technology that can be used to measure the exact location of sown seeds.
As the title says, I am a rookie and my major is not measurement and control or sensors. This year I was admitted to the graduate school of agricultural mechanization. My supervisor gave me a task to

Datasheet More

Circuits More