CN0259

High-performance 65 MHz bandwidth quad-channel IF receiver with anti-aliasing filter and 184.32 MSPS sampling rate

Schematic PCB

CN0232

Minimize frequency synthesizer spurious output from integrated VCO and external PLL circuitry

Schematic PCB

CN0239

Broadband 6 GHz active mixer with seamless LO interface

Schematic PCB

CN0248

IQ demodulator-based IF to baseband receiver with variable IF and baseband gain and programmable baseband filtering

Schematic PCB

CN0283

Provides fixed power gain at the output of the IQ modulator

Schematic PCB

CN0285

Wideband Low Error Vector Magnitude (EVM) Direct Conversion Transmitter

Schematic PCB

CN0290

Extending the low-frequency range of high-performance phase-locked loops

Schematic PCB

CN0294

Increase the number of clock source outputs using low-jitter LVPECL fanout buffers

Schematic PCB

CN0311

Wideband low error vector magnitude (EVM) direct conversion transmitter using LO divide-by-2 modulator

Schematic PCB

CN0320

IQ demodulator-based IF to baseband receiver with variable IF and baseband gain and programmable baseband filtering

Schematic PCB

CN0340

True RMS RF detector with 95 dB detection range

Schematic PCB

CN0187

Crest factor, peak and rms RF power measurement circuit optimized for high speed, low power and single 3.3 V supply

Schematic PCB

CN0174

Low-Noise 12 GHz Microwave Fractional-N Phase-Locked Loop (PLL) Using Active Loop Filter and RF Prescaler

Schematic PCB

CN0171

Low noise, low distortion single-ended input driver circuit for differential input IF sampling ADC

Schematic PCB

CN0178

Software calibrated 50 MHz to 9 GHz RF power measurement system

Schematic PCB

CN0150

Build a software-calibrated 1 MHz to 8 GHz, 70 dB RF power measurement system using the AD8318 logarithmic detector

Schematic PCB

CN0147

Utilizing the ADP150 low-noise LDO regulator to power the ADF4350 PLL and VCO to reduce phase noise

Schematic PCB

CN0144

Using LO two-way modulator to build a wideband low-EVM direct conversion transmitter

Schematic PCB

Calibration system for pressure transmitter based on AD855X programmable gain amplifier

This reference design addresses this need for pre-factory calibration and provides a complete multi-channel fully automatic calibration system for pressure transmitter calibration before leaving the factory.

Schematic PCB

1/8 brick power module based on ADP1051

The 1/8 brick power module in this reference design is designed based on the 1/8 brick power supply standard defined by the Distributed Power Open Standards Alliance (DOSA). This power module uses an Analog Devices ADP1051 to control the energy conversion from input to output.

Schematic PCB