Motor Control Analog eLab, 10-part technical video series from Texas Instruments, Avnet and Portescap. Part 5 shows field oriented control techniques for motor system design.
After I installed Quartus 8.0 (successfully cracked), I used its built-in IP generation tool to generate a three-speed Ethernet IP core and a simulation file. When I opened the simulation tool Questas
The 12VDC signal controls the on and off of the 24VDC relay. I want to use a MOS tube to drive it. Is there any economical and small MOS tube to recommend? If there is any other better solution, pleas
I am working on a DSP28035 chip, and the waveform is not correct when configuring the clock in the experiment. So I want to use DSP to control the TOPWAY LCD screen but it fails!DSP+12M crystal oscill
[i=s]This post was last edited by bjhyyq on 2017-7-19 11:35[/i] [align=left][size=14px][b]Preheating 1:[/b]Put the soldering tip in full contact with the solder joint. Figure 1 shows how to heat the s
I use IAR version 5.1, and the MCU model is MSP430F19. I can debug the software normally, but the following error will occur when the hardware is connected. The same error occurs when the MCU and emul