Training

Location:Training / Embedded Development / DSP / Boot Linux kernel via RAM/UBI file system /

本视频“”未发布敬请期待！！！

Duration：7 minutes and 49 seconds
Date：2014/09/10

Uploader：chenyy

Introduction

keywords： OF Linux kernel DSP RAMFS UBIFS processor

As an open source development environment, Linux is favored by more and more users. In actual use, there are many ways to boot the Linux kernel, and there are many configuration and modification options. Use a specific method to boot and start the Linux kernel. These parameters and options need to be coordinated to complete; in this tutorial, we selected the commonly used boot methods RAMFS and UBIFS as examples to explain how to modify the parameter configuration and boot the Linux kernel.

You Might Like

Recommended Posts

EtherCAT master station development case based on TI Sitara AM3352/54/58/59 processor: [i=s] This post was last edited by Bie Da Niu Niu on 2022-6-28 16:13[/i]This article mainly shares with you the specific method of controlling servo motors using the EtherCAT master protocol stack of; 别打牛牛 DSP and ARM Processors

Excuse me, the cc2430 serial port cannot interrupt receiving: The serial port reception in the sample program provided by cc2430 is not in interrupt mode. I wrote a program for receiving in serial port interrupt mode, and found that it clearly received something; arthas Embedded System

Latest hardware testing technology: It is helpful for hardware designers and testers to improve their design and test capabilities. The 59-page content includes: Overview of hardware testing Preparation before hardware testing Types and; linda_xia Analog electronics

Audio software decoding based on libmad: [b]The decoded data is as follows: [/b][b][/b] Please try to download the attachment to view it. Many formats in the post are messed up... I will slowly correct them. [b]1. [/b][b]Preliminary preparat; 微末凡尘 stm32/stm8

The ise simulation results are all high impedance: I am using FPGA to generate sine wave and calling ISE's ROM kernel. However, when simulating, the output is all high impedance. The ROM data is generated by MATLAB. Why is this? module sincose(data,we; kevin_l FPGA/CPLD

Switching Power Supply Interest Group 12th Task: [i=s]This post was last edited by maychang on 2020-11-6 10:14[/i]　　Question 11　　Assume that the primary current waveform of a flyback switching power supply transformer is as shown in Figure (05), wit; maychang Switching Power Supply Study Group

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号