Our company is one of the most important manufacturers of resistor materials, thermoelectric materials for temperature measurement, and passive components for the automotive, electrical and electronics industries. The company sets standards in precision measurement technology for current, voltage and temperature measurement in cars and trucks, hybrid and electric vehicles, as well as industrial systems and systems for the production of renewable energy.
Vorschlag für Leiterplatten Layout (reflowlöten) /
Proposal for pcb-layout (reflow-soldering)
Lötprofil Vorschlag / Recommended solder profile
Reflow-, IR-Löten / Reflow-, IR-soldering
Temperatur /
Temperature [°C]
zeit / Time [s]
260
peak
255
40
217
90
Bei abweichender Lötpadgeometrie kann es zu einer
Verschiebung des gemessenen R-Werts kommen. /
With differing pcb-layout geometry it is possible that
the measured resistance value can vary.
Ausführliche Informationen erhalten Sie auf unserer Homepage:
www.isabellenhuette.de
For more information please visit our website:
www.isabellenhuette.de
RoHS 2002/95/EG konform seit Produktstart.
RoHS 2002/95/EC compliance since product launch.
Eine leichte Verformung beim Löten beeinflusst nicht die technischen
Eigenschaften des Bauteils. /
Slight deformations during soldering do not affect technical properties
of the component.
GuRTINFORMATIONEN /
TAPE & REEL INFORMATION
Norm / Specification
Gurtbreite / Tape width
Anzahl Bauteile / Parts per reel
DIN EN 60286-3
8 mm
12500
BESTELLBEzEICHNuNG / ORDERING CODE
SMK-R010-5.0
Typ /
Type
SMK
Widerstandswert /
Resistance value
10 mOhm
Toleranz /
Tolerance
5.0 %
Gewährleistung
Alle Angaben über Eignung, Verarbeitung und Anwendung unserer Produkte, technische Beratung und sonstige Angaben erfolgen nach bestem
Wissen, befreien den Käufer jedoch nicht von eigenen Prüfungen und Versuchen.
Warranty
All information regarding the suitability, workability and applicability of our products, all technical advice and other information are provided to the
best of our knowledge and belief, but shall not discharge the buyer from his own examinations and tests.
Den aktuellen Stand des Datenblattes finden Sie auf unserer Internetseite - The current valid issue of the datasheet can be found on our website
Grenzkurve für maximale Pulsenergie bzw. Pulsleistung für Dauerbetrieb /
Maximum pulse energy respectively pulse power for continuous operation
10000
1000
Die dargestellte Kurve gilt für den Widerstandswert R005. Für andere Werte kann die Kurve im unteren Bereich ggf. anders verlaufen, so dass in Grenzbereichen eine separate
Qualifikation erfolgen sollte.
This curve is only valid for the resistance value R005. The shape of the curve in the range below 0.1 sec will be different for other resistance values. Therefore a separate
qualification should be made for pulse power close to the above curve.
Spezifikation/Specification
Parameters
Maximum Temperature for full power operation
Working Temperature
Thermal Shock
Overload
Solderability
Resistance to Solvents
Low Temperature Storage and Operation
Resistance to Soldering Heat
Moisture Resistance
Shock
Vibration, High Frequency
Life
Storage Life at Elevated Temperature
High Temperature Exposure
Current Noise
Voltage Coefficient (%/V)
Resistance Temperature Characteristic
Thermal EMF
Frequency Characteristic R<25 mOhm
test conditions
90 °C
-55 to 170 °C
MIL-STD-202 method 107-B1
MIL-R-26E (5 times rated power, 5 sec)
MIL-STD-202 method 208
MIL-STD-202 method 215, 2.1a, 2.1d
MIL-STD-26E
MIL-STD-202 method 210
MIL-STD-202 method 106
MIL-STD-202 method 213-A
MIL-STD-202 method 204-B
MIL-STD-26E
MIL-STD-202 method 108-F
140 °C, 2000 h
MIL-STD-202 method 308
MIL-STD-202 method 309
MIL-STD-202 method 304 (20-60°C)
0 - 100 °C
inductivity
Specification
90 °C
-55 to 170 °C
0.1 %
0.2 %
> 95 % coverage
no damage
0.1 %
0.1 %
0.1 %
0.2 %
0.2 %
0.5 %
0.5 %
0.5 %
0.01 %
linearity error less than 120dB
<50 ppm/K
2 µV/ K max.
< 3 nH
typical data
90 °C
-55 to 170 °C
0.1 %
0.2 %
> 95 % coverage
no damage
0.05 %
0.05 %
0.05 %
0.1 %
0.1 %
0.2 %
0.3 %
0.2 %
0.01 %
linearity error less than 120dB
<30 ppm/K
0.5 µV/ K max.
< 1 nH
Den aktuellen Stand des Datenblattes finden Sie auf unserer Internetseite - The current valid issue of the datasheet can be found on our website
Why does the statement if (ADC12MEM0>=0X7FF) mean ADC12MEM = A0 > 0.5AVcc in MSP430F5529? What does 0X7FF mean and how is it related to AVcc? 155459...
Power Glass is a novel high-tech glass product. It is a new application of LED technology in the field of glass. It not only maintains the ultra-high transparency of glass, but also makes the inside o...
[i=s]This post was last edited by Fengxiaren on 2021-1-16 22:05[/i]The specific circuit diagram is this, Add a chip pin diagramNowRemove D2 and D3 at the back end, do not solder the inductor, and sold...
【Abstract】This paper briefly explains the working principle of the microwave digital phase shifter and introduces a method of using commercial microwave software to complete the phase shifter design w...
Because the STM32 HAL library only has millisecond-level delay for HAl_Delay(), in order to achieve accurate microsecond-level delay, Systick has to be modified. However, since it is used internally ...[Details]
introduction In the general project development process, two or more microcontrollers are often required to communicate to complete data transmission. For example, a quadcopter wirelessly transmits d...[Details]
I have been working on this i2c for several days. Many people on the Internet say that this is a problem with the ST package library, and they basically talk about the STM32F1 series of chips, and ev...[Details]
Recently, the relevant person in charge of the Energy Conservation Division of the Energy Conservation and Technology Equipment Department of the National Energy Administration said on the issue of...[Details]
From last year to now, competition in the photovoltaic inverter industry has become increasingly fierce. In addition to the introduction of new products, various marketing and promotion methods hav...[Details]
As many companies listed with
the concept of
touch screen
begin to "transform and upgrade", the official voice of the TP industry is getting smaller and smaller. At the same time, the list o...[Details]
Unlike three years ago, today's
artificial intelligence
is no longer just a floating concept, and the venture capital circle has begun to explore the various possibilities of this technolog...[Details]
First of all, security practitioners have never felt that AI can be used as deeply as today. Although Antelope Cloud is a platform manufacturer, it has always been interested in AI and AI- specific...[Details]
Household photovoltaic power stations mainly utilize idle resources on existing household buildings, such as roofs, wall facades, balconies, courtyards, etc., to install and use distributed photovo...[Details]
Different models of PIC series microcontrollers have different watchdog settings. The following takes the PIC16F688 microcontroller as an example. 1. If WDTE=1 in the configuration word, the watchdog...[Details]
1. Function and purpose There are two pins BOOT0 and BOOT1 on each STM32 chip. The level status of these two pins when the chip is reset determines which area the program starts from after th...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
