2CW37-15

Entropy Technology (a subsidiary of e-Wang Electronics) and Caroda Technology form a strategic alliance: Strengthening OTA security with PUF technology, positioning for the era of softwa...[Details]

On September 16, MediaTek announced on its official website that its first flagship system-on-chip (SoC) using TSMC's 2nm process has successfully completed design tape-out, becoming one of the wor...[Details]

On September 17, it was reported that SMIC is testing a deep ultraviolet (DUV) lithography machine produced by Shanghai startup Yuliangsheng. The lithography machine being tested uses immersion tec...[Details]

SiFive recently announced a major update to its product portfolio, with new products covering a wide range of applications, from ultra-low-power designs for extreme edge IoT devices to high-perform...[Details]

Abstract: Phase-locked loops are widely used in the measurement and control of power systems. This paper introduces a new type of fully digital phase-locked loop based on proportional integral control...[Details]

Abstract: A fourth-order IIR digital filter is implemented using FPGA. Two second-order sections are cascaded to form a digital elliptic low-pass filter. The ripple in the passband is less than 0.1dB,...[Details]

Abstract: This paper introduces the principle, circuit structure and optimization method of direct digital frequency synthesis (DDS) using field programmable gate array (FPGA). The implementation meth...[Details]

Abstract: This paper briefly introduces the characteristics and application scope of CPLD/FPGA devices, and takes the design of a half-integer divider with a division ratio of 2.5 as an example, intro...[Details]

For the power control of non-pure resistive devices such as halogen lamps, large LED screens and heating coils, it is generally not suitable to use traditional linear voltage control methods. Inste...[Details]

1. Overview The ITT2301AF integrated power amplifier is a product of CaAsTEK, an American company. The amplifier uses the company's self-adjusting MSAG-lite process. It is powered ...[Details]

Abstract: This paper designs a low-voltage, constant-gain, Rail-to-Rail CMOS operational amplifier. The entire circuit is designed using standard 0.6um CMOS process parameters and simula...[Details]

The Fairchild LVTH543 8 transceiver contains two sets of D latches for temporary storage of data streams in different directions. Separate latch enable and output enable inputs provide independent ...[Details]

MRFIC1505 is a 1.575GHz GPS downconverter from Motorola. It is an integrated circuit designed for GPS receiver applications. This dual conversion design is implemented using the company's low-cost,...[Details]

Abstract: Today's electronic system design environment adopts a top-down design method, which achieves a better design trade-off between design cycle, system performance and cost. Based ...[Details]

Abstract: According to the characteristics of the I2C serial expansion of the single-chip microcomputer, the IP core is established using the AHDL language in the environment of the EDA software Maxpl...[Details]