Evaluation board based on the LV8044LP 6-channel motor driver LV8044LPGEVB

Overview

The LV8044LPGEVB, LV8044LP evaluation board, is a 6-channel motor driver IC for digital cameras. The LV8044LP is an H-bridge motor driver that supports low-voltage drive, features a very small, thin package, and offers low Rdson output. The LV8044LP provides serial signal-controlled microstepping, making it an optimal stepper and DC motor driver for portable devices such as digital cameras, security cameras, and CCTV.

Design Files

LV8044LPGEVB, evaluation board based on the LV8044LP 6-channel motor driver.pdf

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-08 22:54:07

CP5711 communication card
Siemens has recently launched the CP5711 communication card to replace the CP5512 communication card originally used for notebook computers. The CP5711 uses a USB interface to connect to the notebook,
Understanding the configuration of C2000 series CMD files
The professional name of CMD is linker configuration file, which stores the configuration information of the linker. We call it command file for short. The key is the use of two pseudo-instructions, M
Materials used when learning STM32
Same problem
Same problem, how to solve it?
I would like to ask a question about timed sampling, thank you
If I want to set the sampling rate to 20K, I think there are two ways: 1: Use the timer as the DMA trigger source, the frequency is 20K, trigger once, and put the data from the ADC into the memory. 2:
Ask some questions about 430 peripheral pins
I want to ask, can all the peripheral pins of msp430 be used to configure the output pwm wave? I am making a wireless car now. When using a single chip microcomputer to control the l298n driver, four

Datasheet More

Circuits More