The PD150 is a compact 150MHz differential oscilloscope probe for engineers on a budget and advanced hobbyists. It has advanced features such as automatic DC offset voltage zeroing and low-frequency common-mode rejection tuning. It will also provide complete documentation in the spirit of old-school "anchor" test equipment, detailing its working principles in addition to typical instructions and specifications.
This open source has a complete host computer, slave computer and schematic diagram, as well as a detailed design paper.
The nRF52840 MDK USB Dongle is a small, low-cost development platform implemented by the nRF52840 multi-protocol SoC in a convenient USB Dongle form factor.
This is a simple USB sniffer based on the Raspberry Pi RP2040. It supports low speed and full speed modes. The firmware presents itself as a virtual COM port (VCP), so no additional software is required and it is compatible with all operating systems.
Commercial electronic loads are more expensive, especially high-power loads such as computer power supplies that must handle transient current spikes well above their nominal ratings (1800W spike for a 600W GPU) and should be tested under worst-case conditions to Ensure stability.
Flirting with jumper caps is a common practice on most boards, but not this board, which is designed to replace all those wires with an analog switch matrix. All one has to do is plug in the device and make a virtual connection on the accompanying GUI. There are also many built-in functions such as DAC and ADC, and the circuit can be switched under the prototype as needed. It also has some LEDs embedded in the breadboard area that light up and provide visual cues that they are connected to each other.
This reference design describes how to use TI's wireless M-Bus stack with the CC1310 and CC1350 wireless MCUs and integrate them into smart meter or data collector products. The software stack is compatible with the Open Metering System (OMS) v3.0.1 specification. EN13757-1 to EN13757-7 are European meter reading standards, including wired and wireless metering buses (M-Bus); these are very popular in ultra-low power metering and sub-metering applications. The design provides ready-to-use binary images for any wireless M-Bus S, T or C mode at 868 MHz, with unidirectional (instrumentation) or bidirectional configuration (instrumentation and datalogger). Multiple precompiled binary images are provided covering metering applications including but not limited to heat cost allocators (HCA), gas, water and heat meters, or electronic meters with external host MCUs.
Single-Pair-Ethernet technology (SPE, Single-Pair-Ethernet) describes the transmission of Ethernet through only a pair of copper cores. In addition to transmitting data through Ethernet, it can also simultaneously provide power to terminal devices through PoDL (power supply over data lines).
The ESPboy CC1101 chip module allows you to detect Sub1Ghz signals (300-348MHz, 387-464MHz, 779-928MHz). Scan, decode, store to open garage doors, obstacles, IoT sensors...
EEWorld
subscription
account
EEWorld
service
account
Automotive
development
community
Robot
development
community
About Us Customer Service Contact Information Datasheet Sitemap LatestNews
Room 1530, 15th Floor, Building B,
No.18 Zhongguancun Street,
Haidian District,
Beijing, Postal Code: 100190
China
Telephone: 008610 8235 0740
京公网安备 11010802033920号
