USB2.0 full-speed analyzer based on Raspberry Pi RP2040

This is a simple USB sniffer based on the Raspberry Pi RP2040. It supports low speed and full speed modes. The firmware presents itself as a virtual COM port (VCP), so no additional software is required and it is compatible with all operating systems.

Schematic PCB

Breadboard without jumpers: Based on Raspberry Pi Pico, analog switch matrix replaces jumpers

Flirting with jumper caps is a common practice on most boards, but not this board, which is designed to replace all those wires with an analog switch matrix. All one has to do is plug in the device and make a virtual connection on the accompanying GUI. There are also many built-in functions such as DAC and ADC, and the circuit can be switched under the prototype as needed. It also has some LEDs embedded in the breadboard area that light up and provide visual cues that they are connected to each other.

Schematic PCB

The early mobile phone system PalmOS was ported to Raspberry Pi RP2040

Schematic PCB

Open source planet exploration vehicle releases V2.0 version

Schematic PCB

TI launches wireless metering bus M-BUS reference design

This reference design describes how to use TI's wireless M-Bus stack with the CC1310 and CC1350 wireless MCUs and integrate them into smart meter or data collector products. The software stack is compatible with the Open Metering System (OMS) v3.0.1 specification. EN13757-1 to EN13757-7 are European meter reading standards, including wired and wireless metering buses (M-Bus); these are very popular in ultra-low power metering and sub-metering applications. The design provides ready-to-use binary images for any wireless M-Bus S, T or C mode at 868 MHz, with unidirectional (instrumentation) or bidirectional configuration (instrumentation and datalogger). Multiple precompiled binary images are provided covering metering applications including but not limited to heat cost allocators (HCA), gas, water and heat meters, or electronic meters with external host MCUs.

Schematic PCB

Based on STM32G431, a compact closed-loop servo driver designed for NEMA17 (42mm) stepper motors

Schematic PCB

Single-button keyboard based on ESP32-S3 with color screen

Schematic PCB

Light-controlled curtains based on STC89C52

Light-controlled curtains based on STC89C52

Schematic PCB

Brushless power tool reference design (handheld electric drill reference design) based on STM32G431 and STDRIVE101

Schematic PCB

2017 Electrical Contest Question K-Analysis of Single-Phase Electrical Appliances-Design Plan and Report (3 National Awards)

Schematic PCB

2017 Electronic Competition H Question-Remote Amplitude and Frequency Characteristics Test Device-Shengyi Works-Circuit Scheme

Schematic PCB

2017 National College Student Electronic Design Competition Question H-Remote Amplitude and Frequency Characteristics Tester-Paper

Schematic PCB

2017 Electronic Competition H Question-Remote Amplitude-Frequency Characteristics Test Device-Design Plan and Report (3 National Awards)

Schematic PCB

2017 Electronic Competition Question B-Rolling Ball Control System National First Report

Schematic PCB

2017 National College Student Electronic Design Competition_Microgrid Simulation System (Question A) Design Report_National Second

Schematic PCB

2017 Electric Power Competition Question A-Microgrid Simulation System-National First Report + Schematic Diagram + Simulation Document (Changsha University of Science and Technology)

Schematic PCB

2018 Electronic Competition Question E-Energy Recovery Device (Xidian University)

Schematic PCB

2018 Electronic Competition Question D-Gesture Recognition Device (Xidian University)

Schematic PCB

2018 Electronic Competition Question D-Gesture Recognition Device (Shandong University)

Schematic PCB

2018 Electronic Competition Question D-Gesture Recognition Device (First Prize in Hebei Province)

Schematic PCB