Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[b]Using Webench to Design the PCB Coil of LDC1000[/b]Download: [url=https://download.eeworld.com.cn/download/qwqwqw2088/555039][b][size=5]Using Webench to Design the PCB Coil of LDC1000[/size][/b][/u...
[size=4][color=darkred]The first high frequency transformer design softwareThe second switching power supply transformer softwareThe third high frequency transformer design[/color][/size]...
To be honest, the first batch of people who passed the test application have only received the express for testing now. The scumbag express delivery point actually stored the express for a month. It w...
Click to downloadHow to overcome the challenges of production replication testingTest coverage – using commercial and off-the-shelf hardware and software;
Investment and development of staff professio...
I am using a DGUS screen. To connect it to the cc3200, I seem to need to use the UART port (?). The DGUS screen has 6 serial ports: vcc, gnd, din, dout. How should I connect the two devices?...
[i=s] This post was last edited by paulhyde on 2014-9-15 09:46 [/i] Feel free to discuss. I hope everyone can use their imagination to express their own opinions....
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
