4.6 TRIM ...................................................................................................................................................................7
I am using cc2530. I am currently using the sample routines of the protocol stack to conduct broadcast and on-demand experiments. First, the coordinator sends periodically (some use the timed trigger ...
Not long ago, XMOS announced that it had obtained ARM authorization. :) Today, I attended the product launch conference of XMOS and launched xcore-xa. Compared with previous products, XA replaced one ...
I wrote the following C program under tornado2.2: #include
#include
#includeint main(void) { Tcl_Interp *pTclInterp = Tcl_CreateInterp(); if(!pTclInterp) { printf("Tcl Interpreter could not be created...
Why can my CAMERA image only be displayed half of the screen on the LCD? Either half of the screen is displayed on the top or the bottom. It can't be displayed in full screen. I set the initialization...
Only debugging can find the problems in the design. The first thing to do in a project is to adjust the power supply circuit. During the debugging of the power supply, I found that the output of LM317...
introduction
my country has a vast territory and a large population. The scale of housing construction is huge, and the amount of residential construction is large and wide. It is still on t...[Details]
1. With the development of modern industry and the continuous improvement of automation, some medium and large control systems have been greatly facilitated, which not only makes control easier, bu...[Details]
The potentiometer is an adjustable electronic component. The main functions of the potentiometer in the circuit are as follows:
1. Used as a voltage divider
A potentiometer is a continuou...[Details]
With concerns about the growing energy crisis, motor efficiency has become an important and timely topic. This is because motors use 63% to 70% of the electricity produced in the United States and ...[Details]
1 Introduction
Ultrasound refers to elastic vibration with a frequency higher than the audible frequency limit (i.e., in the frequency band above 20 kHz). The propagation process of this vib...[Details]
Distributed Wireless Communication System (DWCS) uses distributed antennas, distributed processing control, joint signal processing and other technologies to improve the system's spectrum efficie...[Details]
For battery-powered portable devices, in addition to breaking through the limitations of processing power, the performance of portable system power supplies also needs to be continuously improved. ...[Details]
introduction
Temperature and humidity are the main environmental parameters of industrial and agricultural production. It is of great significance to measure them accurately and timely. Using a s...[Details]
1. Electromagnetic compatibility design
Electromagnetic compatibility refers to the ability of electronic equipment to work in a coordinated and effective manner in various electromagnetic env...[Details]
Modern communication equipment, portable electronic products, laptops, electric vehicles, small satellites, etc. generally use batteries as power sources and are widely used. However, the batteries...[Details]
Brain-computer interface (BCI) is a novel human-computer interface method. It is defined as a brain-computer (computer or other device) communication system that does not rely on the normal output ...[Details]
The situation of "excessive neutral current" mentioned here means that when the three-phase load is balanced, the neutral current is still too large, and the neutral current is more than 1.5 times ...[Details]
The Challenge:
Created to monitor the pulp production process in large paper mills to save energy and reduce costs.
The Solution:
To increase throughput, save energy, and op...[Details]
The construction of voltage and current feedback amplifier application circuits is generally the same, except for a few key points.
Current feedback amplifiers have higher sl...[Details]
1. Introduction
Power flow calculation is the basis for studying steady-state problems of power systems. Since the application of computers to calculate power flow distribution in power sy...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
