SJT07RT-20-41PC-424

For STM32, there are two ways to reset the software:   1) Use the official software library     The system reset function is directly provided in the stm32f10x_nvic.c file of the official software li...[Details]

CMSIS Driver has similar API functions and similar calling methods. It is a further encapsulation based on the ST HAL library. It is much more convenient and simpler to use and configure than the ST ...[Details]

├── STM32_USB_Device_Library                                 USB从设备库 │   │   ├── Class │   │   │   └── hid │   │   │       ├── inc │   │   │       │   └── usbd_hid_core.h │   │   │       └── src │   ...[Details]

The adoption rate of serverless cloud computing is gradually increasing, but it has not yet reached people's expectations. Various surveys show that serverless is still an eme...[Details]

In the project, CPLD is needed to complete part of the algorithm design. The parameters are given by AVR, so the communication between AVR and CPLD needs to be completed. Therefore, a test program is...[Details]

Notes on inverter installation and maintenance: 1. Before installation, you should first check whether the inverter is damaged during transportation. 2. When selecting an installa...[Details]

The pins of stm32 have two uses: GPIO (general purpose io) and AFIO (alternate function io) For some pins (depending on the chip), neither of these two uses exists. For example, in 64-pin products, O...[Details]

I have encountered many problems when tinkering with LD driver recently. I will record them one by one below. Otherwise, who will remember who in five hundred years? 1. Configuration issues of multi-...[Details]

#include "MSP430x24x.h" void main(void) {         // Stop watchdog timer to prevent time out reset         WDTCTL = WDTPW + WDTHOLD; //Watchdog            P4DIR = BIT0|BIT1|BIT2|BIT3; //Set to outpu...[Details]

/********************************************************************** **                                                        ** File : EEPROM.c | Eeprom write and read |                         ...[Details]

//Environment: winavr+avr studio   char temp=0; ISR(TIMER1_COMPA_vect )//interrupt function {     // user code here     temp++;     if (temp==10)     temp=0;     PORTA=temp;     DDRA=0xff; } void ...[Details]

    Each I/O port of the AVR microcontroller corresponds to three registers: DDRx, PORTx and PINx, where DDRx is the data direction, i.e. input or output; PORTx is the state of the internal pull-up r...[Details]

MSP 430  MCU  18B20 Thermometer #include "msp430x22x4.h"  typedef unsigned char uchar;  typedef unsigned int  uint;  #define DQ1 P2OUT |= BIT4 #define DQ0 P2OUT &= ~BIT4  #define DQ_in P2DIR &= ~BIT4...[Details]

The basic command syntax of EMC is actually only 57/58. How to change it depends on your practice.  However, it is always easy for novices to fall into some misunderstandings, and some of the techni...[Details]

; /* = ... ; | ; | ;I. LCD scanning principle: | ;Forward scanning: COM on=V CC ,COM off=1/2VCC, corresponding to SEG=1, it outputs VSS, and 0, it outputs VCC. | ;Reverse scanning: COM on=VSS,COM of...[Details]