When debugging low power consumption, it is best to close the serial port and modify the macro:
HAL_UART=FALSEHAL_UART_DMA=1HAL_UART_ISR=0HAL_UART_TX_BY_ISR=1
However, after the modification, a compil...
[i=s] This post was last edited by Wangbao Electronics on 2015-1-30 10:17[/i] [b][font=宋体][size=14pt]Chapter 11 BMW 1768——DAC (Direct Output and DMA Transmission)[/font][/size][/font][/b][font=宋体][siz...
Theoretically, the measurable bandwidth of Puyuan DS1052E oscilloscope + 100MHz probe is BW=1/sqrt((1/50)^2+(1/100)^2), which is about 44.72MHz. This is the case when using an oscilloscope probe and s...
I would like to ask you again, I have a conflict problem when running PWM interrupt and SCI interrupt in dsp2407 C environment programming. I have read the program for a long time, but I really have n...
I just came across STM32, which is based on the Cortex-M3 core. How many CLOCKs does one instruction use? [[i] This post was last edited by a868247 on 2012-6-29 17:18 [/i]]...
In early 2002, I started to write a working program for an IC card prepaid electricity meter. The meter used Philips' 8-bit 51-expanded single-chip microcomputer
87LPC764
, and wa...[Details]
In
circuit design,
current
measurement
is widely used, and the main fields are divided into three categories: in measurement,
the electric meter
is used to measure the curre...[Details]
China's new energy vehicles are in a transition period from research and development to real industrial development. In 2012, with the intensive launch of new energy vehicle policy planning, the de...[Details]
0. Introduction
In daily life, we often see some special-purpose vehicles. When these vehicles pass through intersections, they often obtain the right of way at intersections by temporarily op...[Details]
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
With concerns about the growing energy crisis, motor efficiency has become an important and timely topic. This is because motors use 63% to 70% of the electricity produced in the United States and ...[Details]
LED lighting: Basic circuit design can be completed in as little as one day
Semiconductor manufacturers are also getting involved in the LED lighting business. The power circuit of LED req...[Details]
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
This article will introduce a design method for a distributed control system used in a tracking car, which can perform distributed control of motor modules, sensor modules, and lighting control mod...[Details]
The ARINC429 bus is one of the most commonly used communication buses between various subsystems of avionics. As the "skeleton" of modern avionics systems, once the bus system or the attached airbo...[Details]
LED is now known as the fourth generation of light sources. High-power LED has many advantages over traditional light sources in outdoor lighting.
1 LED lamps have high light efficiency
C...[Details]
This article focuses on closing the feedback loop of an isolated power supply using a TL431 shunt regulator. The article discusses a method to extend the bandwidth of the power supply control loop ...[Details]
Energy conservation and environmental protection are the main directions of current automotive technology research, and power batteries are the key to electric vehicle technology. Research on powe...[Details]
When developing electronic products with processors, how to improve anti-interference ability and electromagnetic compatibility?
1. The following systems should pay special attention to anti-...[Details]
1 Introduction
The stepper motor is an actuator of an open-loop servo motion system, which is controlled in a pulse mode and outputs angular displacement. Compared with AC servo motors and DC servo ...[Details]