Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s] This post was last edited by hf12345 on 2018-9-4 18:49 [/i]I would like to ask you, the above figure is the measured data of the ad623 instrument amplifier. I originally wanted to get a 160x gai...
[indent][align=left][color=#000000][backcolor=white]printf and scanf are the most commonly used input and output functions in C language. We have been using these two functions since we started learni...
The use of modules and devices with a wide variety of RF interfaces is growing in all kinds of vehicles. Because these modules must meet stringent reliability requirements, reproducible measurement re...
A project has multiple Verilog-written modules, but when adding a simulation node to a file that is not a top-level file, it prompts "no matches". Only by setting this file as a top-level file can the...
Today is the critical moment of Bluetooth communication. It has been verified that the purchased Bluetooth module and PC communication are feasible. Unfortunately, the PCB design is not good, and the ...
ADI Reference Circuit
京公网安备 11010802033920号
EEWORLD
