Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
What are the 315/433MHZ PA models? Please recommend. We currently have CC1101 wireless transceiver chip, but the transmission distance is not very ideal. I want to add a power amplifier, hoping to be ...
[p=26, null, left][backcolor=rgb(255,255,255)]TI C6678 DSP supports multiple communication methods, and TCP/UDP communication through the Ethernet port is one of the methods. This article mainly consi...
What I made is the driver board of LM3S controlling BLDC, which uses the current detection method to obtain the information whether the motor is stalled.
Encountered a strange phenomenon:
1. AD sampli...
Banknote number recognition system based on DSP. This information is from my collection. The copyright belongs to the author. You can learn from it....
As shown in the picture. . Can CD4060 generate 1HZ signal directly? If so, what should be the value of R1, R2, C1? How accurate can it be? Please give me some advice! :) I'd be grateful!...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
