Experiment 2: Configure MCLK and SMCLK to XT1 (XT1 of F5529 is 32.768KHZ) /*1. Configure IO ports 5.4 and 5.5 to XT1 function. */ /*2. Configure XCAP to XCAP_3, that is, a 12PF capacitor. */ /*3. Clea...
[i=s]This post was last edited by tobot on 2020-7-5 21:52[/i]Suddenly I realized that it was the last day and I had to submit it on time.
A brief introduction to my project:
1. Project BackgroundAs we...
The input is 3V, but the other end is not connected to the circuit. The voltage measured by the multimeter is only a few tenths of a volt. However, the output terminal of the signal generator is a nor...
1. Electrical Testing During the production process of PCB boards, it is inevitable that short circuits, open circuits, leakage and other electrical defects will occur due to external factors. In addi...
introduction
At the beginning of this century, Veit used Einthoven's galvanometer to record the electrical activity of the human pregnant uterus from the body surface for the first time. In 19...[Details]
The circuit shown in the figure is a three-digit tachometer used to measure low frequency signals with a repetitive time interval of 0.235 to 15 seconds. The tachometer has a speed range of 4 to 255 r...[Details]
Signal sources have developed to a very wide range today. We can classify them according to the frequency range: ultra-low frequency (0.1m～1kHz), audio (20Hz～20kHz), video (20kHz～10MHz), radio fre...[Details]
introduction
Cars are becoming an indispensable part of people's lives. However, what worries car users is that the theft of cars is increasing year by year. This paper aims to design a conven...[Details]
1 Introduction
Intelligent software agents are software programs that can perform specific tasks for users, have a certain degree of intelligence, can autonomously perform some tasks, and ...[Details]
Anyone who has owned a laptop computer will have noticed that when running on battery power, their portable device behaves differently than when running on AC mains power—the display dims, the proc...[Details]
Abstract:
Under high dynamic conditions, combined with GEC's twelve-channel correlator GP2021, this paper discusses the structural design of GPS receivers and the key technologies inv...[Details]
Abstract: In many SCART applications, due to the complex signal switching requirements, dedicated ICs are usually used to implement SCART connections. This will bring cost pressure to single SCART ...[Details]
Abstract: This paper analyzes the technical characteristics of mobile streaming media and the core technical protocol of mobile streaming media - H.264 protocol, and explains the two major domesti...[Details]
Today, many wireless devices combine GSM, WCDMA, Bluetooth, WLAN, GPS and FM technologies and support the high data rates required for mobile Internet. Moreover, as customers demand mobile wireless...[Details]
0 Introduction
With the release of the "Elevator Supervision and Inspection Regulations", new requirements have been put forward for the inspection quality of elevators by inspection agenc...[Details]
The dual-field-of-view infrared optical system can simultaneously provide two images with different magnifications and fields of view. The large field of view in the system has a lower resolution a...[Details]
0 Introduction
With the rapid development of modern science and technology and the progress of society, service robots are becoming more and more closely connected with people's lives,...[Details]
The challenge facing today's automotive electronics engineers is to build low-cost, fail-silent automotive systems that work even when they fail. Braking, steering, and other vehicle stability cont...[Details]
1 Introduction
The brushless DC motor uses an electronic commutation device to replace the mechanical commutation device of the traditional DC motor, and has similar mechanical character...[Details]
MCU
京公网安备 11010802033920号
EEWORLD
