Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s]This post was last edited by wufeijian on 2016-3-31 17:29[/i] I received the Demo board on Monday, but I have been putting it off because I have not had the conditions to test it. Today, the PCI-...
1. Determine the polarity. First, set the multimeter to the R×1KΩ position. When measuring with the multimeter, if the resistance between one pole and the other two poles is infinite, and the resistan...
Radio Frequency Circuit Design: Theory and Applications 2nd Edition
https://download.eeworld.com.cn/detail/guiyuaqnbabao/617324Fourier Transform and Its Applications (3rd Edition)
https://download.eew...
I am a beginner in microcontrollers, and I hope that experts can help me. The simulation is normal, but it does not work when soldered to the circuit board. Only the first LED on the circuit board lig...
From a technical perspective, there are currently two ways to display images on a display wirelessly.
The first method is to transmit video data. The way it works is that at the video transmitter, t...
Integrated technical exchanges
京公网安备 11010802033920号
EEWORLD
