Why not create a discussion area for uCOS-II? ??? There are also products based on uCOS-II in the industry![[i]This post was last edited by Panda on 2010-12-25 20:32[/i]]...
[i=s] This post was last edited by amo_1 on 2014-8-11 17:16 [/i] Thank you? As shown in the figure, because the chip will filter out the negative part, how to judge whether the waveform above the X ax...
See attached picture 1, there are three low-power modes of STM32F030: Sleep, Stop, Standby; See attached picture 2, STM32F030 and RS485 circuit schematic; Question: When STM32F030 is in low-power mode...
When using the sensor, the APC220-43 wireless transceiver module is used. I would like to ask how to design the priority when multiple wireless modules send data and receive it, so as to receive it:)...
When I run a three-phase induction motor, I use a simple voltage model to observe the flux linkage, and the observed speed is floating. Isn't it said that the voltage model can also run normally at me...
1. Introduction to A3 series power input inrush current limiting module 1. Introduction to power supply Due to its advantages in volume, weight and efficiency, switching power supply has been more and...
High efficiency and low standby power consumption are two major challenges in today's switching power supply design. Resonant topology or LLC topology is becoming increasingly popular because it ca...[Details]
When the WDP500-2A plane grating monochromator is used to test the emission wavelength of a high-power laser diode at different currents, the matching of the laser diode has the disadvantages of lo...[Details]
Google's driverless technology is not only an eye-catching technology, but also a subversion of the car usage model.
Those who have watched anti-terrorism films and TV dramas must have been im...[Details]
In public places such as schools, government agencies, factories and mines, as well as public corridors in residential areas, the phenomenon of long-burning lights is very common, which causes a h...[Details]
With the development and widespread application of computer technology, especially in the field of industrial control, computer communication is particularly important. Although serial communication g...[Details]
Overview
As a remote network communication control method with advanced technology, high reliability, complete functions and reasonable cost, CAN-bus has been widely used in various automa...[Details]
1 Introduction
Building Automation System (BAS) is a distributed monitoring system (DCS) designed according to distributed information and control theory. It is the result of the mutual de...[Details]
1 Introduction
With the development of control, computer, communication, network technology, etc., a new control technology, namely fieldbus, has emerged in the field of industrial control...[Details]
0 Introduction
With the rise and continuous improvement of the solid-state lighting industry, light-emitting diodes (LEDs) have become an alternative lighting technology and are gr...[Details]
12v Lead Acid batteries used in trucks, cars, RVs and uninterruptible power supplies are usually rated at 12V. This circuit monitors the battery, the charge and discharge curves, gives the cu...[Details]
LED guardrail lights use fluorescent tubes or LEDs as light sources and continuous guardrails as carriers to form an approximately linear guardrail light strip. This article mainly introduces...[Details]
Since the late 1990s, with the demand for higher system efficiency and lower power consumption, the technological update of telecommunications and data communication equipment has promoted the deve...[Details]
introduction
Steam turbines are driven by high-temperature and high-pressure steam generated by boilers to run at high speed. They are key power equipment in thermal power plants. The emergenc...[Details]
As the global LED market demand continues to increase, my country's LED industry will face huge opportunities in the future. However, the core LED technology and patents are basically monopolized b...[Details]
Rated capacity refers to the maximum output power of the UPS (the product of voltage V and current A).
Usually, the UPS power supplies sold on the market are marked with "W" (watt) for smaller...[Details]