Common Flux Thinner
Thinner
Description:
Common Flux Thinner is a solvent that is used to thin Water Soluble, No Clean and RMA fluxes in foaming and
some spray applications. Common Flux Thinner is typically used in conjunction with the AIM n.020 Titration
Kit. Use of Common Flux Thinner is suggested when the flux acid number is too high due to solvent evaporation
or residues increase due to evaporation. Follow the instructions outlined in the AIM n.020 Titration Kit
procedure when diluting flux products.
Process Control:
-
-
Monitor titration at frequent intervals. At least every four hours is recommended.
If titration requires the addition of Common Flux Thinner, measure desired quantity and add directly to flux
pot.
Physical Properties:
Parameter
Visual
Odor
Specific Gravity
Value
Clear, Colorless
Slight Alcohol Odor
0.79 (water = 1)
Parameter
Flash Point
Boiling Point
pH
Value
< 12°C
82°C
N/A
Handling:
-
-
-
-
-
-
-
-
Common Flux Thinner has an unopened shelf life of 2 years when stored at room temperature.
Do not store Common Flux Thinner in direct sunlight.
Do not freeze this product.
Re-seal any opened containers while not in use.
Common Flux Thinner is shipped ready to use, no mixing necessary.
Use with adequate ventilation and proper personal protective equipment.
Refer to the accompanying Material Safety Data Sheet for any specific emergency information.
Do not dispose of any hazardous materials in non-approved containers.
Safety:
Manufacturing and Distribution Worldwide
Americas +1-401-463-5605 · Europe +44-1737-222-258 · Asia-Pacific +86-755-2993-6487 · info@aimsolder.com · www.aimsolder.com
AIM
IS
ISO9001:2000 C
ERTIFIED
The information contained herein is based on data considered accurate and is offered at no charge. Product information is based upon the assumption of
proper handling and operating conditions. All information pertaining to solder paste is produced with 45-micron powder. Liability is expressly
disclaimed for any loss or injury arising out of the use of this information or the use of any materials designated. Please refer to
http://www.aimsolder.com/terms.cfm
to review AIM's terms and conditions.
11/10
Rev 2
stm32/stm8
京公网安备 11010802033920号
EEWORLD
