There is a project that must use pl/m source insight does not support pl/m is there any editor that can support pl/m, can it have syntax highlighting etc. Thanks...
There are 4 thermal relays at the lower end of a frequency converter. When the circuit breaker at the upper end of the frequency converter is closed under no-load conditions, some of the thermal relay...
Hello everyone, I am working on a graduation project on an automatic music playing circuit based on hardware (FPGA), but I don’t know how to write the opening report. Please help me. There are several...
I was given a developed board to familiarize myself with and use an oscilloscope to test the IO, but there is no separate IO or interface on the board, but both require the driver of the previous chip...
[i=s] This post was last edited by paulhyde on 2014-9-15 09:31 [/i] 8279 keyboard display circuit, is there a circuit diagram I can refer to? Thanks! [[i] This post was last edited by open82977352 on ...
After more than a month of hard work, I finally completed the evaluation task of the RV86 development board. This evaluation focused on the development of the application layer, and did not do any und...
A biped robot joint constructed by pneumatic artificial muscles is introduced. The joint uses the flexible characteristics of pneumatic artificial muscles to effectively control the impact of the la...[Details]
The hardware circuit principle is shown in Figure 1. In the specific design, each part should consider the anti-interference problem to minimize the impact of interference on the performance of the...[Details]
This issue will briefly introduce the test related to spectrum - occupied bandwidth.
Definition: Occupied bandwidth refers to the bandwidth corresponding to 99% of the total transmitted power, cent...[Details]
Introduction With the continuous development of economy, people's demand for automobiles is increasing day by day. Correspondingly, automobile consumer groups are becoming more and more mature. It...[Details]
Power Integrations (PI) has introduced three charger/adapter reference designs using its new LinkSwitch-II series of AC-DC switching power conversion ICs. The new LinkSwitch-II devices use high-pre...[Details]
Abstract:
An amplifier solution for ceramic speaker systems is presented.
Keywords:
audio; ceramic speaker; amplifier; Class G
Today's portable devices require smaller, thinne...[Details]
In recent years, the development of automotive electronic technology has significantly improved vehicle safety performance. One of the technologies that is expected to be widely used is the tire p...[Details]
Abstract:
This paper introduces the excitation system designed for 3/3 phase double winding induction generator, which is composed of DSP and FPGA. The interface circuit of the control sys...[Details]
Billboards are information display terminals for the public, with a wide range of civil and commercial values. However, most of the information displayed on billboards is currently solidified in th...[Details]
The full name of RFID is Radio Frequency Identification, which uses radio frequency to realize data transmission between programmable controller (PLC) or microcomputer (PC) and identification, ther...[Details]
With the continuous development of digital television, the demand for high-definition is imperative. H.264, as a new generation of compression standard, has a more complete algorithm than MPEG-2, ...[Details]
0 Introduction
A gyroscope is an instrument that can accurately determine the direction of a moving object. It is an inertial navigation instrument widely used in modern aviation, navigation...[Details]
Digital signal processors (DSPs) offer excellent multimedia performance. In general, they can run codecs at only 40% to 50% of the cycles of a general-purpose processor (GPP) core. DSPs also offer ...[Details]
Part 1 Current status of electricity metering in various places
Current status of electricity metering
a) Power companies still mainly use mechanical energy meters and low-cost e...[Details]
0 Introduction
With the improvement of the automation level of industrial production in my country, more and more equipment needs to be monitored, operated and maintained in the field....[Details]