The same pin, STM32 is set to input mode. The oscilloscope shows a high level, but the microcontroller pin reads a low level. Has anyone encountered the same phenomenon? What is the reason?...
[i=s] This post was last edited by mzb2012 on 2017-10-26 21:06 [/i] [size=5][b] 1. Introduction [/b][/size] [size=5][b][size=5][b][size=5][/size][/b][/size][/b][size=4] The TPA3128D2 chip is a highly ...
Help: I configured CC430 to 250Kbps, MSK modulation. I want to communicate with CC1200. According to the datasheet, I set the rate to 250kbps, the debugging mode to 2-FSK, and the debugging frequency ...
How is the system clock in sopc determined? The external crystal is 50mhz and is directly connected to the cpu without frequency division. Then I want to write a delay program in the ide, but I am not...
Signal and System Southeast University Mengqiao : https://training.eeworld.com.cn/course/4243Through the study of this course, students should be able to master the basic theories and methods of basic...
[align=left]The voltage source signal has an internal resistance of 100kΩ, a maximum amplitude of 5mV, and a frequency spectrum of 80-100MHz. The voltage output has an output amplitude of 2V when the ...
A line scan lens is an industrial lens used with line scan cameras. Its imaging principle is to capture the image of the workpiece using a linear sensor and then perform digital signal processing t...[Details]
A vacuum eutectic furnace is a critical piece of equipment used in the manufacturing and processing of various materials, particularly in the fields of microelectronics and nanotechnology. One of t...[Details]
Multi-touch mobile phone
Multi-touch is a system that can respond to multiple touches on the screen at the same time. Multi-touch phones are divided into capacitive and resistive types. Capaci...[Details]
According to foreign media reports, Nissan Motor has recently reached a cooperation with US battery technology company LiCAP Technologies to jointly promote the research and development of next-gen...[Details]
UPS stands for Uninterruptible Power Supply, which includes energy storage devices. It is mainly used to provide uninterruptible power supply for devices that require high power stability.
...[Details]
1. Fault phenomenon and cause analysis
1. During the operation of the equipment, the expansion sleeve is subjected to a large torque, and the mating surfaces of the shaft and the sleeve move...[Details]
In the field of communications power supplies, AC/DC rectifier power supplies are called primary power supplies or basic power supplies, while DC/DC converters are called secondary power supplies. ...[Details]
Previously, Positive Motion Technology shared with you the firmware upgrade of motion controller, ZBasic program development, ZPLC program development, communication with touch screen and input/out...[Details]
introduction
In recent years, multi-touch has emerged as a new alternative to traditional human-computer interaction. It eliminates the need for keyboards and mice, enabling simultaneous inter...[Details]
1. Introduction
In 2015, Apple's new MacBook and Apple Watch both featured force-sensing technology, which Apple calls Force Touch. Each time a user presses the touchpad, the device not only p...[Details]
01. Introduction
As in-vehicle networks migrate from the CAN
bus
to
Ethernet
, traditional millisecond-level synchronization accuracy can no longer meet the requirements of mul...[Details]
On August 20, Huawei Device announced that the all-new M7 is the first to feature an in-cabin laser vision solution. This solution offers enhanced active safety capabilities compared to primary vis...[Details]
introduction
With the development of the information superhighway and the internet, broadcast television has become increasingly widespread worldwide. Television information has emerged in var...[Details]
The power transmission system between a car's engine and drive wheels is called its drivetrain. It ensures the necessary traction and speed under various driving conditions, and coordinates these t...[Details]