Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[size=4]1. First, go to the TI official website to download the latest CCS7.3. [/size] [size=4]2. After the download is complete, double-click CCS_SETUP.EXE to install. Be careful not to have Chinese ...
I use spi to drive 74hc595. 595 is connected to a common anode digital tube. When I use ckp=1//high level when idle cke=1//send data from low level to high level. The digital tube displays fine. When ...
Moderator, I am so confused about FSMC. I wonder if there is any information.Now the question is:How to determine the connection method of the 4 chip selects NE1~4 in bank1 of FSMC? For example, why s...
Most of the brothers in the forum may know the WEBENCH tool through activities. I have been in contact with it for a long time. Because I have been using this tool since TI acquired National Semicondu...
Question 2: What is the difference between wires, flying leads and networks? Answer: Wires are also called copper film routing, or simply wires. They are used to connect various solder joints and ar...
[b][color=#5E7384]This content is originally created by EEWORLD forum user [size=3]tiankai001[/size]. If you need to reprint or use it for commercial purposes, you must obtain the author's consent and...
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
