As the title says, Proteus is the best timing simulation software I have ever used. It has a simple interface, is easy to operate, and can also design circuit layouts. It is very good. I have speciall...
I would like to ask you, is there any software like Netmeeting under WINCE? I want to realize voice communication in the local area network, but I don’t know what software can be used. At present, the...
[i=s]This post was last edited by paulhyde on 2014-9-15 09:44[/i]1
20MHzX
60MHz
1Hz~1MHz
1MHz~30MHz1mV10 MHzDDS100 MHz100PLD
20MHz
2A/D D/A100Ω/2A10Ω/5A
2pF~30pF2Ω/36W 10Ω/36W[i=s]This post was last e...
This is my first post, please give me some advice. I am currently working on a switch matrix for multi-power management using Tanner, hoping to get multiple outputs at the same time. Does anyone have ...
As a single-host multi-slave bus system, the number of slave devices that can be connected to a 1-Wire bus is almost unlimited. In order to avoid logical conflicts, the 1-Wire bus interfaces of all...[Details]
In the field of software development, the most critical but also the most unpredictable phase is the debugging phase. There are many factors that play a role in the process of software debugging, a...[Details]
Basic principles of simulation
Simulation is a technology used in the field of embedded system development. It can bring system developers the controllability and visibility needed to integra...[Details]
0 Introduction
Metal halide lamp (MHL) as a green lighting source has been widely used in the field of indoor and outdoor lighting. However, when using this green lighting source, the matc...[Details]
Complex circuits and 3D EM simulation tools have reached a point where complex system-level behavior can be simulated before fabrication. Performing EM simulations simultaneously with circuit simul...[Details]
1. What is fading?
In terms of scope, fading can be roughly divided into three types: large area fading, small area fading and indoor fading. As shown in Figure 1, large area fading refers t...[Details]
Most
embedded
systems are powered from a 48V backplane. This voltage is typically stepped down to a lower intermediate bus voltage of 24V, 12V, or 5V to power the circuit board racks withi...[Details]
1 Introduction to suction laminating machine
Suction laminating machine is a kind of woodworking machinery, which can realize the laminating function of wood boards and other materials. It i...[Details]
Abstract: This paper introduces the controller, interface, display principle and driving method of the handheld computer LCD display based on the SA1110 microprocessor. Combined with the HPC projec...[Details]
Touch sensors have been in widespread use for many years, but recent advances in mixed-signal programmable devices have made capacitive touch sensors a practical, value-added alternative to mechani...[Details]
When it comes to ATX power supply, people will think of two "classic" ICs: pulse width modulation chip TL494 and voltage comparator LM339. The new dedicated control chip AT2005B has the functions ...[Details]
With the rapid development of industrialization and urbanization, people's living environment is facing severe challenges due to the environmental damage caused by life and production. As an enviro...[Details]
The growing global interest in green power has added new variables to the design of power supplies and power adapters. Designers must not only traditionally consider the design specifications requi...[Details]
As process nodes and die sizes continue to shrink, the number of consumer electronic products using flip-chip packaged IC devices is increasing. However, flip-chip packaging manufacturing rules hav...[Details]