In the past two years, due to EMC consulting work, I have been exposed to and understood more and more automotive electronics. The automotive electronics EMC I am talking about here refers to pre-inst...
Do hardware engineers who work on FPGA need to program themselves? Some of my friends are engaged in hardware circuit research and development, based on FPGA/ASIC/ARM, etc. I seem to have heard that t...
Friends in the forum, some went home to get engaged: I wish Xiaotian happiness every day; some went home to see their children: I wish them happiness every day; and some went home to sleep like me: I ...
There are two msp430f147 for asynchronous communication. One is for sending and the other is for receiving. The sending is to send 65 continuously, and the receiving is to store 65 in a fixed position...
Using a desktop inkjet printer, conductive inks such as silver nano-ink and dielectric inks can be used to produce multilayer circuit boards, flexible circuit boards, and even three-dimensional wiring...
[i=s]This post was last edited by Emenact on 2016-7-16 08:49[/i] Not long after I started working with RF, I came across a term: Noise Figure. Baidu defines it as follows: [color=#333333][font=arial, ...
Assume that data is read from 8-bit AD (if it is a higher-bit AD, the data type can be defined as int), the subroutine is get_ad();
1. Limited secondary filtering
/* A value can be adjust...[Details]
1. Introduction
This design was made for participating in an electronic design competition. It effectively solved the problem of the operation and control of an electric car on a seesaw. The s...[Details]
With the advent of increasingly powerful processors, image sensors, memory, and other semiconductor devices, as well as the algorithms that enable them, computer vision can be implemented in a wide...[Details]
Floating-point digital signal processing has become a constant requirement for precision technology, often in applications requiring high accuracy in areas such as aviation, industrial machinery, a...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
1 Introduction
Solar street lights are mainly composed of four parts: solar photovoltaic cell components, batteries, charge and discharge controllers, and lighting fixtures. The bo...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
The automotive lighting and signal control system is responsible for controlling the vehicle's lighting, signal lights, electric horns, reversing and brake buzzers. Traditional automotive lighting...[Details]
The typical fault troubleshooting listed below is for reference of maintenance personnel.
When the computer is turned on, the indicator light is off and there is no screen display
Mainte...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
Overview
In spectral measurement, photomultiplier tubes (PMT) and charge-coupled devices (CCD) are often used as photoelectric converters. PMT is used in slow-changing, high-precision spectral...[Details]