TECHNICAL BULLETIN TB-4017
ESD Bottle Hang Tags
Made in the
United States of America
Figure 2. Item 35393 installed on a 6 oz bottle
Figure 1. ESD Bottle Hang Tag, 35393 (left) & 35394 (right)
Features
• Pre-cut ESD safe hang tag adds additional labeling to
MENDA bottles, with neck size 38-400. (35393 only)
• 0.012” (0.3048 mm) thick,
±10%
tolerance, ESD vinyl
material front and back.
• Dissipative Rtt: 1 x 10
6
to < 1 x 10
10
ohms per
ANSI/ESD S11.11
• Tribocharging is less than 100 volts.
• Includes 2-1/4" x 2-1/4" (Insert Size) front pouch to
prevent the label from getting wet.
• Front pocket includes inner anti-print, non-ESD vinyl
layer, which will prevent ink transfer from the label to
the tag.
• Can fit a folded 8-1/2" x 11" sheet of paper.
• Includes ESD Protective Symbol imprint in bottom left
corner of the front pocket.
ITEM # DESCRIPTION
35393
35394
ESD Bottle Hang Tag, Pre-Cut, 10 Pack
ESD Bottle Hang Tag, 10 Pack
Figure 2. Item 35394 installed on an 8 oz wash bottle
3651 Walnut Avenue, Chino, CA 91710
Phone: (909) 627-2453 • Web Site:
MendaPump.com
TB-4017
Page 1 of 2
November 2015
© 2015 DESCO INDUSTRIES, INC.
Employee Owned
Cutting Instructions for 35394 Bottle Hang Tag
1. Fold the uncut bottle hang tag in half lengthwise.
4. With sharp scissors or a utility knife, cut along the
traced line mark from the previous step.
2. Fold down the unmarked top of the tag to the mid-seam
line; it should be facing towards the ESD Symbol.
5. Remove the marked section completely, and unfold the
hang tag.
3. Place the folded corner on top of the bottle neck and
using a pen or marker, trace where the edge of the
bottle neck meets the vinyl tag. The tip of the folded
corner should be centered in the middle of the bottle
neck opening with the outside edge of the hang tag
facing in the direction of the hand holding it.
6. Check the fit of the hang tag by placing it over the bottle
neck. Repeat steps and trim if needed.
Limited Warranty, Warranty Exclusions, Limit of
Liability and RMA Request Instructions
See the Menda warranty -
http://menda.descoindustries.com/warranty.aspx
3651 Walnut Avenue, Chino, CA 91710
Phone: (909) 627-2453 • Web Site:
MendaPump.com
TB-4017
Page 2 of 2
© 2015 DESCO INDUSTRIES, INC.
Employee Owned
京公网安备 11010802033920号
EEWORLD
