Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
C0G Dielectric, 10 – 250 VDC (Commercial Grade)
Packaging C-Spec Ordering Options Table
Packaging Type
1
Bulk Bag/Unmarked
7" Reel/Unmarked
13" Reel/Unmarked
7" Reel/Unmarked/2 mm pitch
2
13" Reel/Unmarked/2 mm pitch
2
1
1
Packaging/Grade
Ordering Code (C-Spec)
Not required (Blank)
TU
7411 (EIA 0603 and smaller case sizes)
7210 (EIA 0805 and larger case sizes)
7081
7082
Default packaging is “Bulk Bag”. An ordering code C-Spec is not required for “Bulk Bag” packaging.
The terms “Marked” and “Unmarked” pertain to laser marking option of capacitors. All packaging options labeled as “Unmarked” will contain
capacitors that have not been laser marked. The option to laser mark is not available on these devices. For more information see “Capacitor Marking”.
2
The 2 mm pitch option allows for double the packaging quantity of capacitors on a given reel size. This option is limited to EIA 0603 (1608 metric) case
size devices. For more information regarding 2 mm pitch option see “Tape & Reel Packaging Information”.
Benefits cont'd
• Preferred capacitance solution at line frequencies and into the MHz range
• No capacitance change with respect to applied rated DC voltage
• Negligible capacitance change with respect to temperature from −55°C to +125°C
I want to use lm324n to realize 10mv-20mv voltage comparison and output it to the lcd to light up. No output is less than 10mv and greater than 20mv. I am a novice asking for advice. Thank you....
I recently encountered such a problem during circuit debugging.System Description:The DDS core in the FPGA is used to generate a sine wave signal with a frequency of several hundred Hz, which is conve...
[i=s]This post was last edited by dontium on 2015-1-23 11:46[/i] Determination of jump noise: From the perspective of time domain, the time domain model of jump noise does not conform to Gaussian dist...
I want to monitor the deletion of files, and I hooked ZwSetInformationFile, but I found that when I use Shift+Delete to delete files, the value of FileInformationClass is FileDispositionInformation, b...
An amplifier drives a 4 ohm speaker. The amplifier uses TDA2030a, the supply voltage is ±15V, the output power is 20W, and the output current is about 3.5A. I hope the master can provide a switching p...
Electronic systems are increasingly using RF sources in radio frequency (RF) applications such as automotive radar, 5G cellular, and the Internet of Things. All of these RF sources require ways to mon...
UHF and HF are both general technology categories, but each category has independent supporting protocols. HF is more consistent in the 13.56MHz frequency band, although there are many internation...[Details]
TD-SCDMA (Time Division Synchronous Code Division Multiple Access) is one of the three major standards for the third generation of mobile communications. It is a communication standard with indepen...[Details]
Digital signal processors have efficient numerical computing capabilities and can provide a good development environment, while programmable logic devices have highly flexible configurability. This...[Details]
Overview
Bioelectric signals are very weak, and there is strong interference when detecting them. Therefore, there are many technical difficulties in designing high-quality bioelectric ampli...[Details]
With the development of automatic control technology, the application of precision air pressure generation and control technology is becoming more and more extensive. However, the traditional valve...[Details]
1 Introduction
Intelligent software agents are software programs that can perform specific tasks for users, have a certain degree of intelligence, can autonomously perform some tasks, and ...[Details]
The rapid growth of consumer video applications, from portable media players and cell phones to video game consoles, requires a multitude of different interfaces and adapters to enable users to tra...[Details]
Abstract:
Under high dynamic conditions, combined with GEC's twelve-channel correlator GP2021, this paper discusses the structural design of GPS receivers and the key technologies inv...[Details]
Abstract
: This paper introduces the general structure of the driver under the currently popular open source embedded operating system μClinux, as well as the connection between the touch scr...[Details]
Abstract: In many SCART applications, due to the complex signal switching requirements, dedicated ICs are usually used to implement SCART connections. This will bring cost pressure to single SCART ...[Details]
Abstract: This paper analyzes the technical characteristics of mobile streaming media and the core technical protocol of mobile streaming media - H.264 protocol, and explains the two major domesti...[Details]
Register transfer level (RTL) verification is still a bottleneck in digital hardware design. Industry research shows that functional verification accounts for 70% of the entire design work. But eve...[Details]
Overview and application status of IC card access control
IC Card Access Control Overview
System Overview: Use IC card as the carrier to realize identity recognition and access co...[Details]
This year marks the 25th anniversary of the birth of FPGA and the 25th anniversary of the founding of Xilinx. At this special moment, I have two important messages to share with you: The first mess...[Details]
After more than 20 years of development, Ethernet has become an indispensable part of the underlying connection in modern Internet. It is easy to network and has better openness, making it one of t...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
