16Mb SDRAM
16Mb ( 2Banks ) Synchronous DRAM
EM481M1622VTA (1Mx16)
Description
The EM481M1622VTA is Synchronous Dynamic Random Access Memory (SDRAM) organized as
512K x 2 banks x 16 bits. All inputs and outputs are synchronized with the positive edge of the clock.
The 16Mb SDRAM uses synchronized pipelined architecture to achieve high speed data transfer rates
and is designed to operate at 3.3V low power memory system. It also provides auto refresh with power
saving / down mode. All inputs and outputs voltage levels are compatible with LVTTL
.
Feature
synchronous to positive clock edge
•
Single 3.3V +/- 0.3V power supply
• LVTTL compatible with multiplexed address
• Programmable Burst Length (B/ L) - 1,2,4,8 or full page
• Programmable CAS Latency (C/ L) - 2 or 3
• Data Mask (DQM) for Read / Write masking
• Programmable wrap sequence - Sequential ( B/ L = 1/2/4/8/full page )
- Interleave ( B/ L = 1/2/4/8 )
• Burst read with single-bit write operation
• All inputs are sampled at the rising edge of the system clock.
• Auto refresh and self refresh
• 2,048 refresh cycles / 32ms
•
Fully
* EOREX reserves the right to change products or specification without notice.
2/18
Rev.01
16Mb SDRAM
Pin Descriptions ( Simplified )
Pin
CLK
/CS
CKE
Name
System Clock
Chip select
Clock Enable
Pin Function
Master Clock Input(Active on the Positive rising edge)
Selects chip when active
Activates the CLK when “H” and deactivates when “L”.
CKE should be enabled at least one cycle prior to new
command. Disable input buffers for power down in standby.
Row address (A0 to A10) is determined by A0 to A10 level
at the bank active command cycle CLK rising edge.
CA(CA0 to CA7) is determined by A0 to A7 level at the
read or write command cycle CLK rising edge.
And this column address becomes burst access start
address. A10 defines the pre-charge mode. When A10 = High
at the pre-charge command cycle, all banks are pre-charged.
But when A10 = Low at the pre-charge command cycle,
only the bank that is selected by BA is pre-charged.
Selects which bank is to be active.
Latches Row Addresses on the positive rising edge of the
CLK with /RAS “L”. Enables row access & pre-charge.
Latches Column Addresses on the positive rising edge of the
CLK with /CAS low. Enables column access.
Latches Column Addresses on the positive rising edge of the
CLK with /CAS low. Enables column access.
A0 ~ A10
Address
BA
Bank Address
/RAS
Row address strobe
/CAS
Column address strobe
/WE
Write Enable
UDQM /LDQM
Data input/output Mask
DQM controls I/O buffers.
DQ0 ~ 15
Data input/output
DQ pins have the same function as I/O pins on a conventional
DRAM.
V
DD
/V
SS
V
DDQ
/V
SSQ
NC
Power supply/Ground
Power supply/Ground
No connection
V
DD
and V
SS
are power supply pins for internal circuits.
V
DDQ
and V
SSQ
are power supply pins for the output buffers.
This pin is recommended to be left No Connection on the
device.
4/18
Rev.01
Talking
京公网安备 11010802033920号
EEWORLD
