Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
:Cry: All you MSP430 experts, please help!I want to use the MSP430 minimum system version and DS18B20 to measure the temperature and display the data on the 12864LCD!Could you help me write the code?U...
Shanghai, China, July 8, 2021 – VIAVI Solutions recently released the latest version of the "5G Deployment Status" report, which is the fifth year that VIAVI has released this report. According to the...
Question 10 : 1. Figure (01) in this article is copied from "Magnetic Components in Switching Power Supplies". If the closed curve in the figure is the magnetization curve of the filter inductor core...
2.4-inch TFT screen, with touch screen, ILI9320 driver! The pin definition is as follows:[img]http://cache.ourdev.cn/new2012/forum/201205/06/1221273f3pt2kvae3pzmt3.jpg.thumb.jpg[/img]Uploaded at 12:21...
1. First open the project's operation -- c/c++ compiler - Preprocessor and add NV_RESTORE2 Set the PAN ID by pressing the button. This part is written according to your own hardware.
3 If I set the ID...
I am a DSP newbie. Recently, I used the DSP5509A development board, which contains an AIC23 audio codec chip, a MIC and LINEIN input channel. First of all, I want to ask if it can only work in one mod...