Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
mouse_event(MOUSEEVENTF_TOUCH,10,10,0,0); Is the coordinate value wrong? I want to use the MOUSE_EVENT function to simulate the action of TOUCH PANEL...
Click here to view all submitted worksClick here to enter the 2020 ST MEMS Sensor Creativity Competition Award Ceremony, paying tribute to those who dare to challenge and persist~LSM6DSOX+STEVAL-MKI10...
Maybe some people still don't know what time synchronization and frequency synchronization are, but we all know GPS, Beidou and GLONASS. Maybe some people are experts in time and frequency synchroniza...
1. Write an interrupt service routine
Write an ISR function c_intXX in the .c source file for interrupt processing, such as:
interrupt void c_intXX (void)
{…;
}
Note: For hardware interrupts, XX = 00~...
The setting is: AT+CNMI=2,1 When the MCU receives the message, sometimes there is a new message prompt, and sometimes there is no new message prompt (no prompt is the majority of the time). Why is thi...
Embedded System
京公网安备 11010802033920号
EEWORLD
