LEAD FINISH (SnPb) ARE IN EOL PROCESS - LAST TIME BUY EXPIRES JUNE 15, 2018
CMOS SyncFIFO
™
64 x 9, 256 x 9, 512 x 9,
1,024 x 9, 2,048 x 9,
4,096 x 9 and 8,192 x 9
IDT72421, IDT72201
IDT72211, IDT72221
IDT72231, IDT72241
IDT72251
FEATURES:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
64 x 9-bit organization (IDT72421)
256 x 9-bit organization (IDT72201)
512 x 9-bit organization (IDT72211)
1,024 x 9-bit organization (IDT72221)
2,048 x 9-bit organization (IDT72231)
4,096 x 9-bit organization (IDT72241)
8,192 x 9-bit organization (IDT72251)
10 ns read/write cycle time
Read and Write Clocks can be independent
Dual-Ported zero fall-through time architecture
Empty and Full Flags signal FIFO status
Programmable Almost-Empty and Almost-Full flags can be set
to any depth
Programmable Almost-Empty and Almost-Full flags default to
Empty+7, and Full-7, respectively
Output enable puts output data bus in high-impedance state
Advanced submicron CMOS technology
Available in the 32-pin plastic leaded chip carrier (PLCC) and
32-pin Thin Quad Flat Pack (TQFP)
For through-hole product please see the IDT72420/72200/72210/
72220/72230/72240 data sheet
Industrial temperature range (–40°C to +85°C) is available
°
°
Green parts available, see ordering information
The IDT72421/72201/72211/72221/72231/72241/72251 SyncFIFO™
are very high-speed, low-power First-In, First-Out (FIFO) memories with
clocked read and write controls. These devices have a 64, 256, 512, 1,024,
2,048, 4,096, and 8,192 x 9-bit memory array, respectively. These FIFOs are
applicable for a wide variety of data buffering needs such as graphics, local area
networks and interprocessor communication.
These FIFOs have 9-bit input and output ports. The input port is controlled
by a free-running clock (WCLK), and two write enable pins (WEN1, WEN2).
Data is written into the Synchronous FIFO on every rising clock edge when
the write enable pins are asserted. The output port is controlled by another clock
pin (RCLK) and two read enable pins (REN1,
REN2).
The Read Clock can
be tied to the Write Clock for single clock operation or the two clocks can run
asynchronous of one another for dual-clock operation. An output enable pin
(OE) is provided on the read port for three-state control of the output.
The Synchronous FIFOs have two fixed flags, Empty (EF) and Full (FF).
Two programmable flags, Almost-Empty (PAE) and Almost-Full (PAF), are
provided for improved system control. The programmable flags default to
Empty+7 and Full-7 for
PAE
and
PAF,
respectively. The programmable flag
offset loading is controlled by a simple state machine and is initiated by asserting
the load pin (LD).
These FIFOs are fabricated using high-speed submicron CMOS technology.
DESCRIPTION:
FUNCTIONAL BLOCK DIAGRAM
WCLK
WEN1
WEN2
D
0
- D
8
LD
INPUT REGISTER
OFFSET REGISTER
EF
PAE
PAF
FF
WRITE CONTROL
LOGIC
RAM ARRAY
64 x 9, 256 x 9,
512 x 9, 1,024 x 9,
2,048 x 9, 4,096 x 9,
8,192 x 9
FLAG
LOGIC
WRITE POINTER
READ POINTER
READ CONTROL
LOGIC
OUTPUT REGISTER
RESET LOGIC
RCLK
REN1
REN2
RS
OE
Q
0
- Q
8
2655 drw01
IDT and the IDT logo are registered trademarks of Integrated Device Technology, Inc. The SyncFIFO is a registered trademark of Integrated Device Technology, Inc.
I used to only know how to write some small programs for MCUs, but now I find that I don't know how to test the performance of drivers. I think wince drivers are similar to win32 drivers. How should t...
After adding simplified Chinese fonts to wince 6.0, NK.bin has 33M. I want to increase NK.bin to 35M. 1. Modify Bootloader\Eboot\eboot.bib as follows: //#define ROM_RAMIMAGE_SIZE 0x02000000 #define RO...
What is the definition of the AT command set? Is it complicated? Is it troublesome to use it? I am a layman. I want to understand the AT command set and how to learn to use it better and faster....
[i=s] This post was last edited by suoma on 2017-5-6 08:33 [/i] I was in a good mood on 4.30 and bought a dress. However, it has not been shipped today. I asked the buyer and he gave me the following ...
For RF engineers, the receiver sensitivity of their own design is one of the most concerned and important parameters. So let's first look at the definition of receiver sensitivity:The minimum signal l...
Why does fatal error RC1015: cannot open include file 'afxres.h' appear every time I create a menu? After I create a menu, I include "resource.h" and compile. This error occurs every time. I have trie...
We are entering a new era where people are increasingly affordably equipped with more electronic gadgets. Electronics have become essential to our lives. For example, the average consumer now owns ...[Details]
Amidst the wave of intelligent automotive transformation, advanced driver assistance is gradually emerging from cutting-edge technology into the mainstream, becoming a new frontier of industry comp...[Details]
Charging is a familiar process for new energy vehicles, and as a source of battery energy, charging piles are crucial. New energy vehicle charging can be divided into fast charging and slow chargin...[Details]
1. Multi-channel DAC technology bottleneck
Currently,
the development of multi-channel DAC technology focuses on two core challenges.
First, industrial applications urgently ...[Details]
Coal mines typically contain gas and coal dust. When gas and coal dust reach a certain concentration, they can cause explosions. Electrical equipment generates arcs during normal operation or durin...[Details]
During daily operation of an R-type power transformer, the voltage used varies as the equipment being used adjusts. This raises the question: can the transformer change voltage at this point? The a...[Details]
Bosch has released a new SoC series to support L2+ advanced driver assistance functions. The chip integrates high resolution and long-range detection capabilities, and has built-in support for neur...[Details]
Shenzhen Baowei Power Supply high frequency pure sine wave power, communication inverter power supply has two communication interfaces, RS232 and R485 interfaces, their functions and characteristic...[Details]
Wearable technology is taking off, with applications evolving rapidly, from smartwatches to fitness trackers and even smart wigs! Bluetooth Smart is at the center of this revolution. This is the se...[Details]
Recently, I received a request to use OK1028A-C to output PWM square wave. However, I found that there was no relevant instructions on the OK1028 platform, so I started writing this article.
A...[Details]
On August 19, Huawei's Executive Director and Chairman of the Device BG, Richard Yu, shared a Weibo post about a conversation he had with a Zunjie S800 owner. The owner had driven over 5,000 kilome...[Details]
The transition to SDVs (software-defined vehicles) involves more than just replacing parts; rather, it involves the organic connection of various elements, from internal vehicle systems to ext...[Details]
The number of new energy vehicles in use is increasing, and there are multiple choices available. New energy vehicles can be divided into hybrid and pure electric, and the types of hybrid include m...[Details]
System Principle
According to the average imbalance rate of the branch three-phase phase line load and the average value of the branch phase line current, the adjustment of the phase line load...[Details]
The BB-Black is a development platform based on the TI AM335X processor, manufactured and sold by Embest under license from BeagleBoard.org. The BB-Black boasts superior graphics performance among ...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
