Important notes
The following applies to all products named in this publication:
1. Some parts of this publication contain
statements about the suitability of our products for
certain areas of application.
These statements are based on our knowledge of typical
requirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out
that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application.
As a
rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them
than the customers themselves. For these reasons, it is always ultimately incumbent on the
customer to check and decide whether an EPCOS product with the properties described in the
product specification is suitable for use in a particular customer application.
2. We also point out that
in individual cases, a malfunction of electronic components or failure
before the end of their usual service life cannot be completely ruled out in the current state
of the art, even if they are operated as specified.
In customer applications requiring a very high
level of operational safety and especially in customer applications in which the malfunction or
failure of an electronic component could endanger human life or health (e.g. in accident
prevention or life-saving systems), it must therefore be ensured by means of suitable design of the
customer application or other action taken by the customer (e.g. installation of protective circuitry
or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or
failure of an electronic component.
3.
The warnings, cautions and product-specific notes must be observed.
4. In order to satisfy certain technical requirements,
some of the products described in this
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as hazardous).
Useful information on this will be found in our Material
Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed
questions, please contact our sales offices.
5. We constantly strive to improve our products. Consequently,
the products described in this
publication may change from time to time.
The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also
reserve the right to discontinue production and delivery of products.
Consequently,
we cannot guarantee that all products named in this publication will always be available.
The aforementioned does not apply in the case of individual agreements deviating from the
foregoing for customer-specific products.
6. Unless otherwise agreed in individual contracts,
all orders are subject to the current version of
the “General Terms of Delivery for Products and Services in the Electrical Industry”
published by the German Electrical and Electronics Industry Association (ZVEI).
7. The trade names EPCOS, Alu-X, CeraDiode, CeraLink, CeraPad, CeraPlas, CSMP, CSSP,
CTVS, DeltaCap, DigiSiMic, DSSP, ExoCore, FilterCap, FormFit, LeaXield, MiniBlue, MiniCell,
MKD, MKK, MotorCap, PCC, PhaseCap, PhaseCube, PhaseMod, PhiCap, PQSine, SIFERRIT,
SIFI, SIKOREL, SilverCap, SIMDAD, SiMic, SIMID, SineFormer, SIOV, SIP5D, SIP5K, TFAP,
ThermoFuse, WindCap are
trademarks registered or pending
in Europe and in other countries.
Further information will be found on the Internet at www.epcos.com/trademarks.
Surge Arrester
3-Electrode-Arrester
T90-A230XG
Ordering code:
B88069X6660T103
DC spark-over voltage
1) 2) 3)
DC spark-over voltage
2) 4)
Impulse spark-over voltage
at 100 V/µs - for 99 % of measured values
3)
- for 50 % of measured values
3)
at 1 kV/µs
- for 99 % of measured values
3)
- for 50 % of measured values
3)
184 ... 276
176 ... 550
< 650
< 550
< 800
< 700
>1
< 1.5
200
5
5
5
5
< 150
< 150
< 150
2
~ 0.8
-40 ... +90
40/ 90/ 21
230 YY O
230
YY
O
- Nominal voltage
- Year of production
- Non radioactive
V
V
V
V
V
V
GΩ
pF
A
kA
kA
A
rms
A
rms
ms
ms
ms
A
g
°C
Insulation resistance at 100 V
dc 3)
Capacitance at 1 MHz
3)
Impulse life
300 operations
10/1000 µs
5)
Nominal impulse discharge current
10 operations
8/20 µs
5)
10 operations
8/20 µs
6)
Nominal alternating discharge current
10 operations
50 Hz; 1 s
5)
10 operations
50 Hz; 1 s
6)
DC holdover voltage
8)
at 52 V
dc
/ 260
Ω
at 80 V
dc
/ 330
Ω
at 135 V
dc
/ 1300
Ω
Activation after reflow soldering
7)
1 operation
U
RMS
= 600 V; 1 s
Weight
Storage temperature
Climatic category (IEC 60068-1)
Marking, blue
At delivery AQL 0.65 level II, DIN ISO 2859
In ionized mode
3)
Tip or ring electrode to center electrode
4)
Tip to ring electrode
5)
Total current through center electrode, half value through
tip respectively ring electrode
6)
Total current through center electrode, same value through
tip respectively ring electrode
7)
Total current from ring to tip electrode
8)
Test in accordance with ITU-Rec. K.12
Terms in accordance with ITU-T Rec. K.12 and DIN 57845/VDE 0845
2)
1)
AB E / AB PM
Page 1 of 2
Issue 04, 28.05.2002
Analog electronics
京公网安备 11010802033920号
EEWORLD
