NEW
Optopipe
TM
Optical Light Pipe
Illuminated Corner, 6 Array
®
515-1041
Recommended
MicroLED SMT LEDs
for use with 515-1041
35.05
[1.38] REF
45.21
[1.78] REF
30.48
[1.20] REF
40.39 [1.59]
29.95 [1.18]
2.43
15.03 [.592]
[.096]
4.57
2.18
[.180]
[.086]
2.79
[.110]
3.81
[.150]
4.06
[.160]
DIRECTIONS
OF LIGHT
5.00
[.197]
5.00
[.197]
FRONT
PANEL
DIFFUSED
FRONT
SURFACES
28.96
[1.14]
C.L. LED
.51
[.020]
MAX
4.06
[.160]
1.60
[.063]
FRONT
PANEL
4.55
[.179]
PART NO.
597-3xx1-2xx
597-3xx1-5xx
597-77x1-2xx
597-77x1-5xx
PAGE #
1-21
1-30
1-23 & 1-24
1-31
2
11.30
[.445]
2.92
[.155]
4 TYP;
SLOT
11.07
[.436]
2.67
[.105]
6.50
[.256]
4.83
[.190]
2 PLCS
Dimensions in mm [inches]
TOP
SURFACE
OF LED
Features
•
•
•
•
•
•
High transmissivity polycarbonate material
UL94V-0 compliance
ESD protection (circuit isolation from front panel)
Wide viewing angle
Arrays reduce insertion costs
Secures to panel by heat staking
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Operating/Storage Temperature
–30°C to +100°C
Dialight
Optopipe
Light Pipe Description
This Optopipe™ illuminates the radiused corner of a plastic housing. The light pipe is heat staked to the case at the
forked tabs at the front of the part. The light pipe is not attached to the PCB at any point but floats above it. The gently
arcing end sticks through the plastic panel. The surface is textured to diffuse the light passing through it. The
recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The SMT LEDs are mounted
in a straight line under the rear of the part on a 6.50mm pitch. The light pipe material is water clear transmissive
polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com
2-59
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
