I. IntroductionThere is a position sensor that measures position changes. I used the voltage range of a multimeter to measure the output signal of the sensor, and the result showed an analog signal, t...
[font=Arial][b][size=3] Capacitors are common components in switching power supplies. They can be used to reduce ripple noise and improve the stability and transient response of power supplies. There ...
Zhou Ligong's tutorial for LPC2103 is relatively simple and easy to understand. I would like to share it with you.[[i]This post was last edited by mdq123 on 2012-7-2 09:36[/i]]...
UF2 is a new binary file format developed by Microsoft for PXT (also known as Microsoft MakeCode), which can update programs through MSC (Mass Storage Class, also known as removable flash drive). Simi...
I just installed MC33063 (same as 34063) today. According to the value calculated in the figure, with a load of 20 ohm resistor, the measured ripple reached 50 millivolts! How much did you achieve whe...
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:59[/i][CCID News] Since 2005, IPTV has rapidly become one of the hottest topics in the field of radio, television and telecommunication...
In order to prevent traffic accidents, when the intelligent detection device of the car detects danger ahead, it must send a warning message to the driver. The voice alarm clearly reminds the drive...[Details]
This article discusses how to use an ultra-low-power RF transceiver chip from Zarlink Semiconductor for pacemakers, neurostimulators, drug pumps, and other such implantable medical devices to achiev...[Details]
introduction
With the rapid development of my country's aviation industry, various new aircraft and control equipment have been successfully developed. Some previous measurement and control eq...[Details]
Lithium-ion batteries have a high energy-to-weight and energy-to-volume ratio, no memory effect, can be recharged many times, have a long service life, and are becoming increasingly cheaper. A good...[Details]
There are many ways to attenuate signals. The most commonly used method is to divide the voltage using resistors. The common circuits are as follows:
Oscilloscope pre-stage attenuation c...[Details]
IPTV (Internet Protocol TV or Interactive Personal TV), also known as interactive network television, is a new technology that uses broadband network infrastructure, takes home televisions or comp...[Details]
Combined with Samsung's ARM9 series embedded processor S3C2410, this paper explains how to perform modular programming of LCD driver and how to statically load the driver into the system kernel.
...[Details]
introduction
With the increasing popularity of Internet applications, the degree of information sharing is constantly improving. The digitization and networking of embedded devices has b...[Details]
Battery system architecture
For many years, nickel-cadmium batteries and later nickel-metal hydride battery technology have dominated the market. Lithium batteries have only entered ...[Details]
Nowadays, video conferencing has become a situation where multiple manufacturers supply various high-definition products. The technology of high-definition products has greatly matured, the cost h...[Details]
0Introduction
Microactuators, as driving components of microelectromechanical systems (MEMS), have been widely studied. In recent years, actuators made of hard magnetic and soft magnetic m...[Details]
With the rapid development of industrialization and urbanization, people's living environment is facing severe challenges due to the environmental damage caused by life and production. As an enviro...[Details]
After being widely adopted in applications such as backlighting of portable products with small and medium-sized screens, light-emitting diodes (LEDs) have entered the field of general lighting in ...[Details]
The ADSP-TS101-based high-speed signal processing system adopts an integrated system design. The hardware part introduces the design method of signal integrity analysis to design high-speed digital...[Details]