EEWORLDEEWORLDEEWORLD

Part Number

Search

LM75BTP,147

Description
Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin HWSON EP T/R
File Size322KB,37 Pages
ManufacturerNXP
Websitehttps://www.nxp.com
Environmental Compliance
Download Datasheet Parametric Compare View All

LM75BTP,147 Overview

Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin HWSON EP T/R

LM75BTP,147 Parametric

Parameter NameAttribute value
EU restricts the use of certain hazardous substancesCompliant
ECCN (US)EAR99
Part StatusActive
HTS8542.39.00.01
Module/IC ClassificationIC
Resolution (bit)11
Accuracy±3°C(Max)
Interface TypeSerial (2-Wire, I2C)
Output TypeDigital
Minimum Operating Supply Voltage (V)2.8
Typical Operating Supply Voltage (V)3.3|5
Maximum Operating Supply Voltage (V)5.5
Maximum Supply Current (uA)300
Minimum Operating Temperature (°C)-55
Maximum Operating Temperature (°C)125
PackagingTape and Reel
Supplier PackageHWSON EP
Pin Count8
MountingSurface Mount
Package Height0.73
Package Length2
Package Width3
PCB changed8
Lead ShapeNo Lead
LM75B
Digital temperature sensor and thermal watchdog
Rev. 6.1 — 6 February 2015
Product data sheet
1. General description
The LM75B is a temperature-to-digital converter using an on-chip band gap temperature
sensor and Sigma-Delta A-to-D conversion technique with an overtemperature detection
output. The LM75B contains a number of data registers: Configuration register (Conf) to
store the device settings such as device operation mode, OS operation mode, OS polarity
and OS fault queue as described in
Section 7 “Functional description”;
temperature
register (Temp) to store the digital temp reading, and set-point registers (Tos and Thyst) to
store programmable overtemperature shutdown and hysteresis limits, that can be
communicated by a controller via the 2-wire serial I
2
C-bus interface. The device also
includes an open-drain output (OS) which becomes active when the temperature exceeds
the programmed limits. There are three selectable logic address pins so that eight devices
can be connected on the same bus without address conflict.
The LM75B can be configured for different operation conditions. It can be set in normal
mode to periodically monitor the ambient temperature, or in shutdown mode to minimize
power consumption. The OS output operates in either of two selectable modes:
OS comparator mode or OS interrupt mode. Its active state can be selected as either
HIGH or LOW. The fault queue that defines the number of consecutive faults in order to
activate the OS output is programmable as well as the set-point limits.
The temperature register always stores an 11-bit two’s complement data giving a
temperature resolution of 0.125
C.
This high temperature resolution is particularly useful
in applications of measuring precisely the thermal drift or runaway. When the LM75B is
accessed the conversion in process is not interrupted (that is, the I
2
C-bus section is totally
independent of the Sigma-Delta converter section) and accessing the LM75B
continuously without waiting at least one conversion time between communications will
not prevent the device from updating the Temp register with a new conversion result. The
new conversion result will be available immediately after the Temp register is updated.
The LM75B powers up in the normal operation mode with the OS in comparator mode,
temperature threshold of 80
C
and hysteresis of 75
C,
so that it can be used as a
stand-alone thermostat with those pre-defined temperature set points.
2. Features and benefits
Pin-for-pin replacement for industry standard LM75 and LM75A and offers improved
temperature resolution of 0.125
C
and specification of a single part over power supply
range from 2.8 V to 5.5 V
I
2
C-bus interface with up to 8 devices on the same bus
Power supply range from 2.8 V to 5.5 V
Temperatures range from
55 C
to +125
C

LM75BTP,147 Related Products

LM75BTP,147 LM75BGD,125 LM75BD,118 LM75BDP,118 | Temperature Sensor
Description Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin HWSON EP T/R Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin XSON-U T/R Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin SO T/R Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin TSSOP T/R
EU restricts the use of certain hazardous substances Compliant Compliant Compliant Compliant
ECCN (US) EAR99 EAR99 EAR99 EAR99
Part Status Active Active Active Active
HTS 8542.39.00.01 8542.39.00.01 8542.39.00.01 8542.39.00.01
Module/IC Classification IC IC IC IC
Resolution (bit) 11 11 11 11
Accuracy ±3°C(Max) ±3°C(Max) ±3°C(Max) ±3°C(Max)
Interface Type Serial (2-Wire, I2C) Serial (2-Wire, I2C) Serial (2-Wire, I2C) Serial (2-Wire, I2C)
Output Type Digital Digital Digital Digital
Minimum Operating Supply Voltage (V) 2.8 2.8 2.8 2.8
Typical Operating Supply Voltage (V) 3.3|5 3.3|5 3.3|5 5|3.3
Maximum Operating Supply Voltage (V) 5.5 5.5 5.5 5.5
Maximum Supply Current (uA) 300 300 300 300
Minimum Operating Temperature (°C) -55 -55 -55 -55
Maximum Operating Temperature (°C) 125 125 125 125
Packaging Tape and Reel Tape and Reel Tape and Reel Tape and Reel
Supplier Package HWSON EP XSON-U SO TSSOP
Pin Count 8 8 8 8
Mounting Surface Mount Surface Mount Surface Mount Surface Mount
Package Height 0.73 0.45(Max) 1.45(Max) 0.95(Max)
Package Length 2 2.1(Max) 5(Max) 3.1(Max)
Package Width 3 3.1(Max) 4(Max) 3.1(Max)
PCB changed 8 8 8 8
How does WinCE system access shared folders on PC?
As the title says. I want to copy files from a remote PC using code on a PDA. I planned to write a bat file and use CMD commands to do it. But it doesn't work when connecting to a remote share. Now I'...
zhangpeng263 Embedded System
How can the EZ430-RF2500 ADC reach 200KSPS?
I am working on a project recently, which requires using the EZ430-RF2500 ED to sample a sine wave and wirelessly send it to the AP. The sampling frequency is required to be above 100KBPS, and 200 is ...
kaosun Microcontroller MCU
I copied the information about C# events and delegates I saw online.
Original post address: http://www.cnblogs.com/jimmyzhang/archive/2007/09/23/903360.htmlI reposted it, the copyright belongs to the original author! :)Delegates and Events in C#PDF Browse: http://www.t...
小小白 Programming Basics
I want to make an interactive command similar to vxworks shell, please help?
VxWorks shell can use the hyperterminal to interact with people through the serial port. I want to write a task that also needs to read the commands sent from the serial port to perform the correspond...
mikerain Real-time operating system RTOS
LPC15XX Routine Program - Zhou Ligong
Today, Zhou Ligong released the LPC15XX routine on his website, which is a good thing for friends who are learning to use LPC15XX. The file is too large to upload: [url]http://www.zlgmcu.com/download/...
电子微创意 NXP MCU
I want the circuit diagram of the light control sensor and the temperature control sensor giving the microcontroller 1 and 0 signals respectively! ! ~~~
For my graduation project, I want to make a switch that can be controlled by light and temperature. Since I don't have any knowledge of commonly used devices, I hope seniors can give me some hardware ...
yunalps Embedded System

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 2662  2353  2692  695  38  54  48  55  14  1 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号