Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level( surge immunity:Line-Line:1KV ),EAC TP TC 020
380.7Khrs min.
MIL-HDBK-217F (25
℃
)
121*77*28.5mm(L*W*H)
0.43Kg; 24pcs/ 11.3Kg/ 0.74CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25
℃
of ambient temperature.
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De-rating may be needed under low input voltages. Please refer to STATIC CHARACTERISTIC sections for details.
4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time or set up failure
5. Aux. 12V will be damaged with short circuit; It will not be available when output voltage is not in constant current region or output no load condition.
6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be
affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
7.The DALI version driver does not support the bit 1: Lamp failure in the Command 144 Query status of the DALI standard.
8. The ambient temperature derating of 3.5
℃
/1000m with fanless models and of 5
℃
/1000m with fan models for operating altitude higher than 2000m(6500ft).
9. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
Block Diagram
ODLC-65
series
fosc : 70KHz
RECTIFIERS
EMI FILTER
&
RECTIFIERS
POWER
SWITCHING
RECTIFIERS
&
FILTER
AUX+(for
ODLC-65A
)
AUX-(for
ODLC-65A
)
Vo+
Vo-
DIM+(DA+)
DIM-(DA-)
I/P
CURRENT
LIMIT
DETECTION
CIRCUIT
O.L.P.
PWM&PFC
CONTROL
DRIVING METHODS OF LED MODULE
※
This series works in constant current mode to directly drive the LEDs.
In the constant current region, the highest voltage at the output of the driver
depends on the configuration of the end systems.
Constant
Current area
Should there be any compatibility issues, please contact MEAN WELL.
100
75
(min.)
Hiccup
Protection
Vo(%)
50
100
Io(%)
Typical output current normalized by rated current (%)
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
DIMMING OPERATION
ODLC-65
series
AUX-(Green)*
AUX+(Yellow)*
Vo-(Black)
Vo+(Red)
DIM- (DA-)(Gray)
DIM+ (DA+)(Purple)
ACN(Blue)
ACL(Brown)
*AUX-/AUX+ only for ODLC-65A
※
2 in 1 dimming function
Output constant current level can be adjusted by applying one of the two methodologies between DIM+ and DIM-:
0 ~ 10VDC, or 10V PWM signal.
Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers.
◎
Applying additive 0 ~ 10VDC
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
Additive Voltage
-
+
-
70%
60%
50%
40%
30%
20%
10%
0%
0V 1V
2V 3V 4V 5V 6V 7V 8V 9V 10V
Dimming input: Additive voltage
DIM-
“DO
NOT connect "DIM- to Vo-"
◎
Applying additive 10V PWM signal (frequency range 300Hz ~ 3KHz):
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
-
70%
60%
50%
40%
30%
20%
Additive PWM signal
DIM-
“DO
NOT connect "DIM- to Vo-"
10%
0%
0% 10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Duty cycle of additive 10V PWM signal dimming input
Note : 1. Min. dimming level is about 8% and the output current is not defined when 0%<
I
out<8%.
2. The output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle.
※
DALI Interface (primary side; for DA-Type)
Apply DALI signal between DA+ and DA-.
DALI protocol comprises 16 groups and 64 addresses.
Problem of judging processor status: This is what is written in the book, but I don't quite understand it. ------------------- Original text: When an exception occurs, the processor automatically swit...
Sorui, this post is still based on the previous post [url=https://bbs.eeworld.com.cn/thread-543043-1-1.html]【KW41z】Access the Thread network terminal to the public network to light the lamp[/url], and...
I wanted to use LM Flash Programmer to download the program to LM3S6432 through the serial port, but the baud rate did not match.Please advise how to use it.Thanks in advance....
ME is a fan of jingling dingdangdang, and I think I have collected all the news about my big brother. That uh... Don't get me wrong, I'm not here to dig up the truth. I respect, love, cherish and admi...
Does a 64-bit CPU have 64 bits in address lines or 64 bits in data lines? What about a 64-bit machine? The question is as above? Is it a 64-bit machine or a 64-bit CPU that can expand memory to 2 to t...
I recently used VS2013 to develop Bluetooth for PCs. There is almost no information about VS2013 on the Internet, and many APIs are outdated. Does anyone have any information about this? It seems that...
On August 24th, Tesla CEO Elon
Musk
revealed information about the upcoming FSD V14, claiming it will outperform human drivers. Tesla FSD lead Ashok stated last year that FSD version 12.5, ...[Details]
There are many different ways of human-computer interaction. The more common ones are listed below:
Mouse interaction: Using a mouse to operate a computer and interact was the most common human...[Details]
Current Development Status of DVR Market
A DVR, or digital video recorder, uses a hard disk for recording, unlike traditional analog video recorders. It's often called a DVR because it's a com...[Details]
On August 21st, Zhiyuan Robotics revealed at its first partner conference that it expects shipments to reach thousands of units this year and tens of thousands next year. The company hopes to reach...[Details]
As the scale and business applications of national e-government networks continue to expand, the data and services transmitted over them are becoming increasingly sensitive and critical. To protect...[Details]
Normally, we determine our location and where we want to go by comparing our surroundings with observation and simple GPS tools. However, this kind of reasoning is very difficult for self-driving c...[Details]
1. Ease of Use: The HMI module should be designed to be simple and clear, allowing users to easily operate and configure the energy storage device.
2. Ease of Maintenance: The HMI module should...[Details]
On August 22, according to CNBC's report today, the National Highway Traffic Safety Administration (NHTSA) is launching an investigation into Tesla, and the latter is questioned whether it has fail...[Details]
I recently read an article in the Wall Street Journal titled "We need the right to repair our gadgets" (reference original article: ). The author was very angry about the phenomenon of "planned obs...[Details]
0 Introduction
With a rapidly aging population, a young couple is now required to care for an increasing number of elderly people, leading to a growing difficulty in providing care for them. E...[Details]
The characteristics of electric vehicles place high demands on the motors they use. To increase top speed, the motor should have high instantaneous power and power density (W/kg); to increase drivi...[Details]
We know that the power output by the engine does not directly act on the wheels to drive the car, but needs to pass through a series of power transmission mechanisms. So how is the power transmitte...[Details]
In recent years, with the development of MOSFETs, they have gradually replaced transistors in the low-power, fast-switching industry. Major manufacturers in this field have also been reducing their...[Details]
Electronic devices are small individual components in electronic circuits. Transistors are common electronic components. Because of their wide range of applications, according to the usage of the e...[Details]
Currently, PLCs are widely used in various industries, including special machine tools, machine tools, control systems, building automation, steel, petrochemicals, electricity, building materials, ...[Details]