We want your feedback!
SofTec Microsystems is always on the look-out for new ways to improve its Products and
Services. For this reason feedback, comments, suggestions or criticisms, however small,
are always welcome.
Our policy at SofTec Microsystems is to comply with all applicable worldwide
safety and EMC/EMI regulations. Our products are certified to comply to the
European New Approach Directives and the CE mark is applied on all our
products.
SofTec Microsystems
E-mail (general information): info@softecmicro.com
E-mail (marketing department): marketing@softecmicro.com
E-mail (technical support): support@softecmicro.com
Web: http://www.softecmicro.com
Important
SofTec Microsystems reserves the right to make improvements to the inDART-One In-Circuit Programmer/Debugger, its
documentation and software routines, without notice. Information in this manual is intended to be accurate and reliable.
However, SofTec Microsystems assumes no responsibility for its use; nor for any infringements of rights of third parties which
may result from its use.
SOFTEC MICROSYSTEMS WILL NOT BE LIABLE FOR DAMAGES RESULTING FROM LOSS OF DATA, PROFITS, USE
OF PRODUCTS, OR INCIDENTAL OR CONSEQUENTIAL DAMAGES, EVEN IF ADVISED OF THE POSSIBILITY
THEREOF.
Trademarks
SofTec Microsystems is a registered trademark of SofTec Microsystems, Spa.
Freescale™ and the Freescale logo are trademarks of Freescale Semiconductor, Inc.
Microsoft and Windows are trademarks or registered trademarks of Microsoft Corporation.
PC is a registered trademark of International Business Machines Corporation.
Other products and company names listed are trademarks or trade names of their respective companies.
DEMO908JL16 User's Manual
Contents
1
Introduction 5
1.1
1.2
1.3
1.4
1.5
Overview 5
Package Contents 5
Supported Devices 5
Recommended Reading 5
Getting Technical Support 6
2
3
Hardware Features 7
2.1
Demonstration Board Features 7
Software Setup 9
3.1
3.2
3.3
3.4
Overview 9
Host System Requirements 9
Installing CodeWarrior Development Studio 9
Installing SofTec Microsystems Additional Components 10
4
Hardware Setup 11
4.1
4.2
First Connection 11
Power Supply 13
5
Operating Modes 15
5.1
5.2
5.3
Overview 15
Standalone Mode 15
Host Mode 15
6
Application Tutorial 17
6.1
6.2
Overview 17
Step-by-Step Tutorial 17
7
Summary of Jumper and Connector Settings 19
7.1
7.2
Jumpers 19
Connectors 20
8
Troubleshooting 25
8.1
USB Driver Problems 25
Page 3