density applications requiring low jitter or tight
stability, including:
• Ethernet
• EPON
• Fibre Channel
• Serial Attached SCSI (SAS)
• Server & Storage platforms
• SONET/SDH linecards
• T1/E1, T3/E3 linecards
• DSLAM
• 802.11a/b/g WiFi
SaRonix-eCera™ is a Pericom® Semiconductor company
•
SaRonix
Product Series
Frequency Stability
A = ±25 ppm (-20 to +70 °C)
B = ±50 ppm (-2 to +70 °C)
E = ±50 ppm (-40 to +85°C)
A: Product Family
B: XXX = Frequency Code
C: YYYY = Specification Code
Following the above format, Saronix-eCera part numbers will be assigned upon
confirmation of exact customer requirements.
Legacy Ordering Information - For Reference Only:
S 1633 B - 125.000 (T)
Packaging
(T) = Tape & Reel
full reel increments
Blank = Bulk packaged
Output Frequency
(MHz)
US: 1-408-435-0800 TW: 886-3-4518888
•
www.saronix-ecera.com
All specifications are subject to change without notice.
FD 3.3V REV2008_DEC04_01.2
1
3.3V CMOS Low Jitter
XO
FD
FD Series Crystal Clock Oscillator (XO)
Legacy S1633 Series | 5.0 x 3.2mm
Electrical Performance
Parameter
Min.
Typ.
Max.
Units
Notes
Output Frequency
Supply Voltage
Supply Current, Output Enabled
Supply Current, Standby Mode
Frequency Stability
Operating Temperature Range
Output Logic 0, V
OL
Output Logic 1, V
OH
Output Load
Duty Cycle
Rise and Fall
Time
Jitter, Phase
Jitter,
Accumulated
Jitter,
Total
up to 40 MHz
40 to 80 MHz
80 to 133 MHz
1 to 133 MHz
up to 80 MHz
80 to 133 MHz
up to 80 MHz
80 to 133 MHz
1
2.97
3.30
133
3.63
15
25
45
10
±20 to ±50
MHz
V
As specified
1 to 50 MHz
mA
μA
ppm
°C
V
V
pF
%
ns
ps RMS (1-σ)
ps RMS (1-σ)
ps pk-pk
50 to 80 MHz
80 to 133 MHz
Output Hi-Z
See Note 1 below
Commercial (standard)
Industrial (standard)
-20
-40
90% V
DD
+70
+85
10% V
DD
15
See Note 2 below
Measured 50% V
DD
Measured 20/80% of waveform
10kHz to 20 MHz frequency band
20.000 adjacent periods
100.000 random periods
45
55
7
5
2.5
1
5
3
50
30
Notes:
1. Stability includes all combinations of operating temperature, load changes, rated input (supply) voltage changes, initial calibration tolerance (25°C),
aging (1 year at 25°C average effective ambient temperature), shock and vibration.
2. For specifications othere than those listed, please contact sales.
Output Enable / Disable Function
Parameter
Min.
Typ.
Max.
Units
Notes
Input Voltage (pin 1), Output Enable
Input Voltage (pin 1), Output Disable (low power standby)
Internal Pullup Resistance
Output Disable Delay
Output Enable Delay
2.0
0.5
50
100
10
V
V
kΩ
ns
ms
or open
Output is Hi-Z
Absolute Maximum Ratings
Parameter
Min.
Typ.
Max.
Units
Notes
Storage Temperature
-55
+125
°C
SaRonix-eCera™ is a Pericom® Semiconductor company
•
US: 1-408-435-0800 TW: 886-3-4518888
•
www.saronix-ecera.com
All specifications are subject to change without notice.
FD 3.3V REV2008_DEC04_01.2
2
3.3V CMOS Low Jitter
XO
FD
FD Series Crystal Clock Oscillator (XO)
Legacy S1633 Series | 5.0 x 3.2mm
Test Circuit
Test Point
Power
Supply
4
0.1μF
or
0.01μF
1
3
2
15 pF
(Including probe
and fixture
capacitance)
Output Enable / Disable Function
Reflow Soldering Profile
As per IPC/JEDEC J-STD-020C
1 to 3°C/sec max
Temperature – °C
260
Peak 260°C for 10 sec max
1 to 3°C/sec
217
Time
60 to 90 sec
4 to 6 minutes max
Reliability Test Ratings
Type
This product is rated to meet the following test conditions:
The operating system is WINCE5.0. The original development board is a PXA270 processor, and the USB Host is connected to a GL850A HUB, with two external USB interfaces. But now we are using the PXA271...
Aren't there only 16 interrupts in a PC, from IRQ0 to IRQ15? Then why do some devices have interrupt numbers greater than 16 in the device manager? For example, my network card has an interrupt number...
ARM and embedded linux training video + dsp CPLD FPGA development video + embedded system development practical technology video rare high-quality learning materials! (It is the teaching content of a ...
It should be the day before yesterday. I have been debugging the SD card and serial port drivers. But suddenly, after I Sysgen the kernel and downloaded it to SDRAM through BIOS, it could not run. The...
The list of winners is as follows. Congratulations to everyone.username
prizeHawthorn pot cake
Mijia desk lampMersenne
Mijia desk lampisunspot@
Mijia desk lamperic.xu
Mijia desk lampLi Jibin
Mijia des...
At present, the development of wireless power supply technology for electric vehicles (EVs) is becoming more and more active. In 2012, Volvo of Sweden established Volvo Technology Japan in Tokyo as...[Details]
1 Introduction
A wide variety of communication cables and control cables are widely used in various instruments and control equipment. Whether the cable is well-conducted and
whether
th...[Details]
Automotive applications are particularly sensitive to EMI events, which are unavoidable in a noisy electrical environment consisting of a central battery, bundled wiring harnesses, various inductiv...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
1 Introduction
With the acceleration of the pace of urban modernization, society has higher requirements for urban road lighting and urban lighting projects. The state has clearly required tha...[Details]
In order to highlight the concept of "energy saving and environmental protection" of intelligent buildings, solar street lights are designed for intelligent communities. The inclination and capacit...[Details]
Although it is relatively easy to check the stability of a simple amplifier at lower frequencies, it may be much more difficult to evaluate the stability of a more complex circuit. This artic...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
This week, Microsoft held its 2012 Microsoft Worldwide Partner Conference (WPC) in Toronto, Canada. At the conference, Microsoft showed its new products and services to partners around the world. A...[Details]
MediaTek (2454) announced the acquisition of F-MStar (3697) and attracted the attention of IC design industry. This morning, Gartner Semiconductor Industry Research Director Hong Cenwei analyzed ...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
Among the many members of the single-chip microcomputer family, the MCS-51 series of single-chip microcomputers has occupied the main market of industrial measurement and control and automation eng...[Details]
From the previous section, we have learned that the timer/counter in the microcontroller can have multiple uses, so how can I make them work for the purpose I need? This requires setting the timer/...[Details]
Liquid crystal display (LCD) panels have a wide range of applications, from small portable electronic devices to large fixed devices, including digital cameras, laptops, personal data assistants, d...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
