The R-78W series offers wired 0.5A switching regulators which are ideally suited to offer a stable
voltage supply without the need for a PCB for applications like high power LED lighting, battery
powered systems, cooling systems, or fans. Due to the high efficiencies of up to 96% there is no
need for a heat sink. The compact modules feature fully protected outputs and draw only 1mA under
no load conditions.
0.5 Amp
SIP3 Wired
Single Output
Selection Guide
Part
Number
R-78W3.3-0.5
R-78W5.0-0.5
R-78W9.0-0.5
R-78W12-0.5
Input
Voltage Range
[VDC]
6.5 - 32
6.5 - 32
11 - 32
15 - 32
Output
Voltage
[VDC]
3.3
5.0
9.0
12.0
Output
Current
[A]
0.5
0.5
0.5
0.5
Efficiency
@ min Vin
[%]
88
93
95
96
Max. Capacitive
Load
(1)
[µF]
220
220
220
220
Notes:
Note1: Max. Cap Load is tested at nominal input and full resistive load
6800µF with <1sec start-up time
Model Numbering
R-78W__-0.5
Output Voltage
Output Current
IEC60950-1 certified
EN60950-1 certified
Specifications
(measured at Ta= 25°C, full load, nominal input voltage and after warm-up)
BASIC CHARACTERISTICS
Parameter
Input Voltage Range
Quiescent Current
Internal Power Dissipation
Minimum Load
(2)
Internal Operating Frequency
Output Ripple and Noise
(3)
Notes:
Note2:
Note3:
20MHz BW limited
0%
280kHz
330kHz
50mVp-p
380kHz
75mVp-p
Condition
nom. Vin = 24VDC
Min.
6.5VDC
Typ.
24VDC
5mA
Max.
32VDC
7mA
0.4W
Operation under no load will not harm the converter, but specifications may not be met
A minimum load of 6mA is recommended
Measurements are made with a 100nF MLCC across output (low ESR)
www.recom-power.com
REV.: 3/2018
I-1
R-78W-0.5
DC/DC Converter
Specifications
(measured at Ta= 25°C, full load, nominal input voltage and after warm-up)
REGULATIONS
Parameter
Output Accuracy
Line Voltage Regulation
Load Voltage Regulation
Transient Response
low line to high line, full load
10% to 100% load
50% - 100% Load,
ΔIo/Δt
25mA/µs
10% - 100% Load,
ΔIo/Δt
25mA/µs
Series
Condition
Type
all models
3.3VDC, 5VDC
9VDC, 12VDC
3.3VDC, 5VDC
9VDC, 12VDC
all models
Value
±2% typ. / ±3% max.
±0.2% typ. / ±0.4% max.
±0.1% typ. / ±0.2% max.
±0.4% typ. / ±0.6% max.
±0.25% typ. / ±0.4% max.
±75mV typ.
±100mV max.
PROTECTIONS
Parameter
Short Circuit Protection (SCP)
Type
Value
continuous, automatic recovery
Reverse Current Protection
internal structure
+V
IN
Controller
+V
OUT
GND
GND
An internal blocking diode can prevent reverse current flow backwards into the output,
as this can damage the converter when it is powered down.
ENVIRONMENTAL
Parameter
Operating Temperature Range
Maximum Case Temperature
Temperature Coefficient
Thermal Impedance
Operating Altitude
Operating Humidity
Pollution Degree
MTBF
according to MIL-HDBK-217F, G.B.
100
90
80
Condition
with derating @ natural convection 0.1m/s (see graph)
-40°C to +85°C ambient
0.1m/s, vertical
non-condensing
+ 25°C
Value
-40°C to +85°C
+100°C
0.015%/°C
70°C/W typ.
2000m
95% RH max.
PD2
9368 x 10
3
hours
Derating Graph
Output Load [%]
70
60
50
40
30
20
10
0
-40 -30 -20 -10
0 10 20 30 40 50 60 70 80 90 100
71 85
Ambient Temperature [°C]
www.recom-power.com
REV.: 3/2018
I-2
R-78W-0.5
DC/DC Converter
Specifications
(measured at Ta= 25°C, full load, nominal input voltage and after warm-up)
SAFETY AND CERTIFICATIONS
Certificate Type (Safety)
Information Technology Equipment, General Requirements for Safety (LVD)
EAC
RoHs 2+
Series
Report / File Number
LVD1407030-1
RU-AT.49.09571
Standard
IEC60950-1:2005, 2nd Edition + AM 2:2013
EN60950-1:2006 + AM:2013
TP TC 004/2011
RoHS 2011/65/EU + AM2015/863
DIMENSION and PHYSICAL CHARACTERISTICS
Parameter
Material
Package Dimension (LxWxH)
Package Weight
Type
case
potting
Value
non-conductive black plastic, (UL94 V-0)
epoxy, (UL94 V-0)
17.5 x 11.5 x 8.5mm
4.8g typ.
Dimension Drawing (mm)
embossed logo
11.5
8.5
17.5
0.51
Marking
Wire/cable information
#
1
2
3
Ø0.76
Ø1.56
Function Wire color Type
+Vin
red
UL-1430
GND
black
UL-1430
+Vout
brown
UL-1430
AWG
22
22
22
Strands
14/0.16
14/0.16
14/0.16
95±5
Tolerance: xx.x= ±0.5mm
xx.xx= ±0.25mm
Bottom View
1 2 3
PACKAGING INFORMATION
Parameter
Packaging Dimension (LxWxH)
Packaging Quantity
Storage Humidity
(3)
10±3
Type
cardboard box
Value
140.0 x 130.0 x 65.0mm
25pcs.
-55°C to +125°C
Storage Temperature Range
non-condensing
Notes:
Note3: 5 bubble packs each containing 5pcs in a cardboard box
95% RH max.
The product information and specifications may be subject to changes even without prior written notice.The product has been designed for various applications; its suitability lies in the responsibility of each customer. The
products are not authorized for use in safety-critical applications without RECOM’s explicit written consent. A safety-critical application is an application where a failure may reasonably be expected to endanger or cause
loss of life, inflict bodily harm or damage property. The applicant shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized
use of RECOM products in such safety-critical applications.
My board doesn't seem to send BOOTME signal. Experts please help me. I used to be able to download nk.bin from pb5 to the target device, but it doesn't work these days. There is always no progress whe...
Due to various reasons, the DIY oscilloscope project was stopped for a while. This morning, the discussion in the group (QQ group: 139459200) rekindled the long-lost enthusiasm. More importantly, the ...
This article and design code were written by FPGA enthusiast Xiao Meige. Without the author's permission, this article is only allowed to be copied and reproduced on online forums, and the original au...
51 MCU Learning Tutorial Jiang Shiming compiled Shaoyang University Information and Electrical Engineering Department October 2, 2005 [b] Contents: [/b] I. Design of advertising lights based on 89S51 ...
I bought a device, which is a full-body conference microphone. After connecting to the video conferencing software, it acts as a microphone and an audio output device.
When connected to the computer v...
On August 24th, Tesla CEO Elon
Musk
revealed information about the upcoming FSD V14, claiming it will outperform human drivers. Tesla FSD lead Ashok stated last year that FSD version 12.5, ...[Details]
The jammer is a signal blocker, mainly composed of a chip and a radio transmitter. When the car owner presses the remote control lock button, the jammer interferes with the electronic lock receivin...[Details]
In the summer of 2025, BlueOval SK, a joint venture between Ford and SK On, officially started production at its first battery factory in Kentucky.
According to the original plan, this w...[Details]
introduction
Sonar imaging is of great significance in marine resource development and defense. Its long range, intuitive display of the observed area, and target identification make it widely...[Details]
introduction
According to the China Fire Statistics Yearbook, electrical fires accounted for more than 30% of fire accidents in the past decade, and the trend is increasing year by year. They ...[Details]
Keysight Technologies is combining its electromagnetic simulator with Synopsys' AI-driven RF design migration flow to create an integrated design flow for migrating from TSMC's N6RF+ process techno...[Details]
The practice of warming up a car originated with gasoline-powered vehicles. Warming up the engine allows it to enter a better working state and ensures good lubrication. This has become a habit for...[Details]
1. Ease of Use: The HMI module should be designed to be simple and clear, allowing users to easily operate and configure the energy storage device.
2. Ease of Maintenance: The HMI module should...[Details]
On August 22, according to CNBC's report today, the National Highway Traffic Safety Administration (NHTSA) is launching an investigation into Tesla, and the latter is questioned whether it has fail...[Details]
Plessey Semiconductors has been acquired by Haylo Labs, which was established in March last year with a $100 million, five-year loan from Chinese technology company Goertek.
Haylo Labs w...[Details]
1. Fault phenomenon and cause analysis
1. During the operation of the equipment, the expansion sleeve is subjected to a large torque, and the mating surfaces of the shaft and the sleeve move...[Details]
In the field of communications power supplies, AC/DC rectifier power supplies are called primary power supplies or basic power supplies, while DC/DC converters are called secondary power supplies. ...[Details]
Introduction: In digital circuit calculations, there is no concept of decimal points. You know where the decimal is, but the circuit does not know where the decimal point is. Therefore, you need to...[Details]
I recently read an article in the Wall Street Journal titled "We need the right to repair our gadgets" (reference original article: ). The author was very angry about the phenomenon of "planned obs...[Details]
Smartphones can be incredibly unintelligent. For example, consider an office full of people, each absorbed in their work. Suddenly, the silence is broken by a burst of loud pop music. A colleague's...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
