7201SYZBE22

The global PV inverter market will shrink from $6.3 billion in 2017 to $3.7 billion in 2022 due to falling prices, according to GlobalData. Global PV Inverter Market Value to Shrink to $3.7 Bil...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

Using Systick timer to achieve delay 1. SysTick timer characteristics The SysTick timer is a 24-bit down counter, that is, when vlue is decremented to 0, an interrupt is triggered and the load va...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

The pins of stm32 have two uses: GPIO (general purpose io) and AFIO (alternate function io) For some pins (depending on the chip), neither of these two uses exists. For example, in 64-pin products, O...[Details]

The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are:  1. User Flash = Flash built into the chip   2.SRAM = RAM area built into the chip, which is the m...[Details]

If you do not use an external crystal on the STM32, the connection method of OSC_IN and OSC_OUT If you use the internal RC oscillator instead of an external crystal, please follow the following metho...[Details]

I have encountered many problems when tinkering with LD driver recently. I will record them one by one below. Otherwise, who will remember who in five hundred years? 1. Configuration issues of multi-...[Details]

When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]

#include reg52.h      #include intrins.h          //unsigned char segout ={0,1,2,3,4,5,6,7}; //8 columns   unsigned char segout ={0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x80}; //8 columns   unsigned char...[Details]

/*-----------------------------------------------     Name: Two-color dot matrix     Forum: www.doflye.net     Written by: shifang     Modification: None     Content: Using hc595 to drive two-color d...[Details]

Manually assemble the following program machine code and analyze the execution function of the program segment.       CLR A       MOV R2, A       MOV R7, #4 LOOP:      CLR C       MOV A, R0       RLC...[Details]

It is required to use timer/counter 1 for timing, with a timing of 1 second; timer/counter 0 for counter, and the external pulse to be counted is connected from P3.4 (T0). The microcontroller will co...[Details]

　　After the first public release of the prospectus of CATL, a new vitality was injected into new energy vehicles. According to market speculation, CATL is expected to issue at around 60 yuan per shar...[Details]