1N28B

1. Principle 1. Infrared emission protocol The infrared transmission protocol has been written in the previous article , so I will not repeat it here. 2. Timer counting and input capture A timer...[Details]

China Energy Storage Network: Blockchain + finance, blockchain + environmental protection, blockchain + insurance, even a roadside fried chicken shop is using the banner of blockchain + fried...[Details]

Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode.  Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows:  ...[Details]

Photovoltaic inverters are the core equipment of photovoltaic systems. Their main function is to convert the direct current generated by photovoltaic modules into alternating current that meets the...[Details]

STM32 has two watchdogs: independent watchdog and window watchdog. This article mainly introduces the use of independent watchdog. Independent watchdog (IDWG): driven by an independent 40KHZ low-sp...[Details]

LiDAR: Autonomous driving from the perspective of optoelectronic technology LiDAR and competing sensor technologies (camera, radar, and ultrasonic) intensify the need for sensor fusion and the need...[Details]

ADI has established long-term good relationships with car manufacturers and Tier 1 component suppliers. Based on its previous long-term successful cooperation with new energy vehicles and suppliers a...[Details]

OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]

Internal channels of ADC:    In addition to using external channels to collect external analog voltage signals, the ADC of STM32 also has two internal channels 16 and 17. Channel 16 is connected to ...[Details]

Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h   typedef unsigned char uchar;   typedef unsigned int uint;   #define ...[Details]

The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs.  Question supplement: The 8051 single-chip microcomputer is used, an...[Details]

A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]

Design a program for the 51 single-chip microcomputer. It is known that the crystal oscillator frequency of the 89C51 single-chip microcomputer is 12MHz, and it is required to use T1 timing to output...[Details]

1. Pin: 0 in 1 out  Set Status  Output status IO register setting          DDR×A certain bit is set to 1, and the corresponding bit IO is set to output;          PORT×A certain position is 1/0, and t...[Details]

　　 After three years of continuous decline in its mobile phone business, ZTE has finally revealed its true feelings to the outside world: the Chinese market is its weak point, and it is planning to f...[Details]