As shown in the figure is a low voltage detection circuit. When the voltage is not lower than 4V, BC547 (the leftmost transistor) is turned on, causing the following two transistors to be cut off and ...
Hello everyone! We found that the serial port data is disordered when using MC9S08QE32, but the program is normal when using MC9S08QE128. What is the reason? Here is our test code: unsigned char *stri...
I want to make a DC motor PWM speed control board. In order to protect the power tube, I have to make an overcurrent protection. I have to connect a sampling resistor to the ground on the power tube. ...
[i=s]This post was last edited by d026530 on 2017-6-15 19:50[/i] [color=#363636]1. Infrared remote control clock. Infrared has three buttons: time +, time -, on/off. [/color] [color=#363636]2. You can...
[align=left][color=rgb(65, 72, 87)][font=-apple-system, system-ui, BlinkMacSystemFont, "]Today, Microsoft announced the acquisition of San Francisco AI company Lobe. Lobe's simple and easy-to-understa...
Passive common mode interference suppression technology based on compensation principle for switching power supply Abstract: This paper introduces a common-mode interference suppression technology bas...
The rapid development of the Internet has realized high-speed information transmission and resource sharing, greatly facilitating people's lives. Embedded systems are widely used in various electr...[Details]
introduction
Solar cells and LED lighting are typical applications of new energy and energy-saving and efficient technologies. Solar LED lighting uses solar cells to convert solar energy...[Details]
As cellular phones become more advanced, the power consumption of the system during operation and the power consumption during standby are also increasing. Therefore, the power management design of...[Details]
0 Introduction
With the development of society, people pay more and more attention to security work. Monitoring products have been used in various fields instead of being used only in importan...[Details]
Vertical cavity surface emitting lasers (VCSELs) are gradually replacing traditional edge emitting lasers, especially in low bandwidth and short-distance communication systems where cost factors ar...[Details]
A standard cell
is an electrochemical
cell
used as a voltage reference standard in many electrical standards laboratories
. If properly maintained, standard cells are very stable. The ...[Details]
Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]
Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]
The DisplayPort interface standard is approved by the Video Electronics Standards Association (VESA) to provide an open, scalable standard for the entire industry. The development of DisplayPort ca...[Details]
LED is the abbreviation of the English word. Its main meanings are: LED = Light Emitting Diode, a solid-state semiconductor device that can convert electrical energy into visible light. It can dire...[Details]
With the popularity of digital appliances, rechargeable batteries can be seen everywhere in people's daily lives and have become one of the indispensable daily necessities.
This article gives ...[Details]
0 Introduction
With the rapid development of modern power electronics technology, various power electronic devices have been widely used in various fields such as power systems, industry, an...[Details]
Designing low power circuits while achieving acceptable performance is a difficult task. Doing so in
the RF
bands increases the challenge dramatically. Today, nearly everything has wireless...[Details]
0 Introduction
PROFIBUS is an open digital communication system with a wide range of applications, which has been included in the international standards IEC 61158 and IEC 61784. Since the gen...[Details]
Globally, the market for airbags and other restraint systems consists of different geographical regions, each with its own characteristics and needs. North America first introduced airbags in mass-...[Details]