For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
Low-Voltage, Triple, Hot-Swap Controllers/
Power Sequencers/Voltage Trackers
MAX5930/MAX5931
ABSOLUTE MAXIMUM RATINGS
(All voltages referenced to GND, unless otherwise noted.)
IN_ ..........................................................................-0.3V to +14V
GATE_.............................................................-0.3V to (IN_ + 6V)
BIAS (Note 1) .............................................. (V
IN
- 0.3V) to +14V
ON_, STAT_, LIM_ (MAX5930), TIM, MODE,
LATCH, POL (MAX5930) ..........................-0.3V to (V
IN
+ 0.3V)
SENSE_........................................................-0.3V to (IN_ + 0.3V)
Current into Any Pin..........................................................±50mA
Note 1:
V
IN
is the largest of V
IN1
, V
IN2
, and V
IN3
.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
The contents of the CD-ROM drive can be viewed by using a command: mount /mnt/cdrom. Why does it say /dev/fd0 is not a valid block device when I use mount /mnt/floppy after inserting the USB drive int...
The automobile transmission system is the general term for all power transmission devices between the automobile engine and the drive wheels. Its most basic function is to transmit power. That is to s...
There are some 3D libraries of commonly used electronic components (resistors, capacitors, diodes, ICs, etc.). I also found them on the Internet. In order to respect the original owner's work, I speci...
The static working current of Lierda 430F413 chip is large (12μA) in the application (basic display circuit),which should be 2μA. Please tell me how to solve it! --------------- Engineer Chen...
The reason why people feel tired is that they often hesitate between persistence and giving up. There are always some things in life that are worth remembering, and there are also some things that mus...
In early 2002, I started to write a working program for an IC card prepaid electricity meter. The meter used Philips' 8-bit 51-expanded single-chip microcomputer
87LPC764
, and wa...[Details]
In this article, the high-performance DSP developed by TI can be used as an effective confidentiality method if it is applied to PC encryption cards.
As an effective network security solution,...[Details]
Contact resistance
is the resistance to current flow through a closed pair of contacts. This type of measurement is performed on devices such as connectors,
relays
, and switches. The...[Details]
1 Introduction to HART Protocol
HART (Highway Addressable Remote Transducer), an open communication protocol for addressable remote sensor high-speed channels, was launched by Rosemen in the U...[Details]
At very low temperatures, certain metals and alloys lose their resistance to electric
current
and become
superconductors
. Two parameters that are often measured are the transition ...[Details]
Capacitors
are basic components in various electronic devices and are widely used for bypassing, coupling,
filtering
, tuning, etc. in electronic circuits. However, to use capacitors,...[Details]
The TPS92210 is a single-stage LED lighting pulse width modulation (PWM) controller. The TRIAC dimmable solution not only regulates the LED current, but also achieves a power factor close to 1. The...[Details]
Our flight had just begun to descend when a gentleman sitting next to me turned to talk to me about engineering—he had seen me reading an engineering journal. The gentleman next to me said that he ...[Details]
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
Car lights, whether headlights, fog lights or tail lights, play an important role in driving safety. However, the material of the car lights determines that the probability of damage in a collision...[Details]
1. The composition and structure of mobile phone lithium battery
Mobile phone lithium batteries are mainly composed of plastic shell upper and lower covers, lithium battery cells, protection c...[Details]
When developing electronic products with processors, how to improve anti-interference ability and electromagnetic compatibility?
1. The following systems should pay special attention to anti-...[Details]
0 Introduction
In microwave, radar, radio and television, and communication systems, the problem of coupling RF power is often encountered. A directional coupler is a directional power divide...[Details]
During the operation of electronic equipment,
memory
failure or failure will not only lead to economic losses, but also may lead to catastrophic consequences. Therefore, memory testing has ...[Details]
When programming in C and assembly, there are interface issues between variables and functions in C and assembly.
Variables defined in a C program are put into the .bss area after being compile...[Details]
Linux and Android
京公网安备 11010802033920号
EEWORLD
