=25°C, Common-mode Line Pressure = 0 psig, Pressure Applied to P1, unless otherwise noted.
Accuracy is the sum of Hysterisis and Linearity. Hysterisis is the maximum output difference at any point within the operating pressure range for increasing and decreasing pressure.
Linearity refers to the best straight line fit as measured for the offset, full-scale and 1/2 full-scale pressure at 25°C.
This is the maximum temperature shift for span when measured between 0°C and 50°C relative to the 25°C reading. Typical temperature coefficients for span and resistance are
-2200 ppm/°C and +2200 ppm/°C respectively.
This is the maximum temperature shift for offset when measured between 0°C and 50°C relative to the 25°C reading.
Span is the algebraic difference between the output voltage at full-scale pressure and the output at zero pressure.
Maximum difference in output at any pressure with the operating pressure range and temperature within
0°C to 50°C after:
a)
100 temperature cycles, 0°C to 50°C
b)
1.0 million pressure cycles, 0 psi to full-scale span
Response time for a 0 psi to full-scale span pressure step change. 10% to 90% rise time
Temp effect on span and offset are guaranteed by design. Therefore these parameters are not 100% tested.
The SCC100D devices can only be used in a forward gauge mode. Application of more than 30 psig to the back side of any of the SCC Series devices can result in device failure.
SenSym and Sensortechnics reserve the right to make changes to any products herein. SenSym and Sensortechnics do not assume any liability arising out of the application or use of any product
or circuit described herein, neither does it convey any license under its patent rights nor the rights of others.
I am currently working on a CC2500 wireless data transceiver module, which communicates via the SPI interface, where SPI is simulated by IO, and the main chip is MSP430G2231. The read and write functi...
[i=s] This post was last edited by mig29ee on 2018-4-30 22:53 [/i] Does anyone have a program for serial port reception with 559? I expected that setting various registers would be a pitfall, and the ...
[align=left][color=#222222][backcolor=rgb(238, 238, 238)][font=sans-serif][color=#2b2b2b][font=simsun, arial, helvetica, clean, sans-serif]China.com, December 14 According to a report on the Russian K...
char *szTemp=NULL; HANDLE hFile= CreateFile(L"\\NAND\\debug.txt", GENERIC_WRITE, 0, NULL, OPEN_ALWAYS, 0, NULL); sprintf(szTemp,"%f",(ppt->y )); //ppt-> is the Y coordinate of the sampling point LONG ...
Synchronous buck converters have gained acceptance as isolated bias supplies in the communications and industrial markets. The isolated buck converter, or Fly-Buck converter as it is commonly called, ...
I've been working on 2401 recently. There's no problem with communication between 51 and 51, but I can't get the result between 430 and 51. I used 22.1184M crystal for 51 and 8M crystal for 430. It sh...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
