EXPOSED PAD (PIN 15) IS GND, MUST BE SOLDERED TO PCB
MSE PACKAGE
16-LEAD PLASTIC MSOP
θ
JA
= 43°C/W,
θ
JC
= 4.3°C/W
EXPOSED PAD (PIN 17) IS GND, MUST BE SOLDERED TO PCB
orDer inForMaTion
LEAD FREE FINISH
LT3509EDE#PBF
LT3509IDE#PBF
LT3509EMSE#PBF
LT3509IMSE#PBF
LT3509HMSE#PBF
TAPE AND REEL
LT3509EDE#TRPBF
LT3509IDE#TRPBF
LT3509EMSE#TRPBF
LT3509IMSE#TRPBF
LT3509HMSE#TRPBF
PART MARKING*
3509
3509
3509
3509
3509
PACKAGE DESCRIPTION
14-Lead (4mm
×
3mm) Plastic DFN
14-Lead (4mm
×
3mm) Plastic DFN
16-Lead Plastic MSOP with Exposed Pad
16-Lead Plastic MSOP with Exposed Pad
16-Lead Plastic MSOP with Exposed Pad
TEMPERATURE RANGE
–40°C to 125°C
–40°C to 125°C
–40°C to 125°C
–40°C to 125°C
–40°C to 150°C
Consult LTC Marketing for parts specified with wider operating temperature ranges. *The temperature grade is identified by a label on the shipping container.
For more information on lead free part marking, go to:
http://www.linear.com/leadfree/
For more information on tape and reel specifications, go to:
http://www.linear.com/tapeandreel/.
Some packages are available in 500 unit reels through
designated sales channels with #TRMPBF suffix.
2
3509fd
For more information
www.linear.com/LT3509
LT3509
elecTrical characTerisTics
PARAMETER
V
IN
Undervoltage Lockout
V
IN
Overvoltage Lockout
Input Quiescent Current
Input Shutdown Current
Feedback Pin Voltage
Reference Voltage Line Regulation
RUN/SS Shutdown Threshold
RUN/SS Voltage for Full I
OUT
RUN/SS Pin Pull-up Current
Feedback Pin Bias Current (Note 4)
Switch Current Limit
DA Comparator Current Threshold
Boost Pin Current
Switch Leakage Current
Switch Saturation Voltage
Minumum Boost Voltage above Switch
Boost Diode Forward Voltage
Boost Diode Leakage
Switching Frequency
I
SW
= 0.9A (Note 5)
I
SW
= 0.9A
I
BD
= 20mA
V
R
= 30V
R
T
= 40.2kΩ
R
T
= 180kΩ
R
T
= 14.1kΩ
l
The
l
denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T
A
= 25°C, V
IN
= 12V. (Note 3)
CONDITIONS
MIN
37
Not Switching V
FB
> 0.8V
V(RUN/SS[1,2]) < 0.3V
l
TYP
3.3
38.5
1.9
9
MAX
3.6
40
2.2
15
0.816
0.8
2
1.3
500
1.9
1.2
36
1.0
2.2
0.9
5
1.08
290
2.5
150
UNITS
V
V
mA
µA
V
%/V
V
V
µA
nA
A
A
mA
µA
V
V
V
µA
MHz
kHz
MHz
V
ns
0.784
0.4
0.7
0.8
0.01
0.6
1
90
1.4
0.95
22
0.01
0.32
1.5
0.7
0.1
3.6V < V
IN
< 36V
V
FB
= 0.8V
l
l
1.05
0.7
I
SW
= 0.9A
0.92
237
2.0
1.0
260
2.15
1.0
80
Sync Pin Input Threshold
Switch Minimum Off-Time
Note 1:
Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device reliability
and lifetime.
Note 2.
Absolute Maximum Voltage at the V
IN
pin is 60V for non-repetitive
1 second transients and 36V for continuous operation.
Note 3.
The LT3509E is guaranteed to meet performance specifications from
0°C to 125°C junction temperature. Specifications over the –40°C to 125°C
operating junction temperature range are assured by design, characterization
and correlation with statistical process controls. The LT3509I is guaranteed
over the full –40°C to 125°C temperature range. The LT3509H is guaranteed
l
over the full –40°C to 150°C operating junction temperature range. High
junction temperatures degrade operating lifetimes. Operating lifetime is
derated at junction temperatures greater than 125°C.
Note 4.
Current flows out of pin.
Note 5.
Switch Saturation Voltage is guaranteed by design.
Note 6.
This IC includes overtemperature protection that is intended to protect
the device during momentary overload conditions. Junction temperature will
exceed the maximum operating temperature when overtemperature protection
is active. Continuous operation above the specified maximum operating
junction temperature may impair device reliability.
There are many electronic books and introductory books. How to choose is a big problem. There are several essential pieces of knowledge in electronic technology, which are roughly theoretical knowledg...
Everyone, I am working on WINCE drivers. These past two days, I have interviewed for the FAE position of Beijing Innoy Video Shenzhen Co., Ltd. and the driver R&D engineer position of VIA Technologies...
When using an IO port of MSP430F149 to output a square wave, whether using a delay or a timer, the maximum frequency of the output square wave can only reach 122.3KHz
The crystal oscillator used is 3....
0. Introduction
In daily life, we often see some special-purpose vehicles. When these vehicles pass through intersections, they often obtain the right of way at intersections by temporarily op...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
1. Overview
The Virtual CAN Interface (VCI) function library is an application program interface specifically provided for the use of ZLGCAN devices on PCs. The functions in the library ar...[Details]
1. Project Introduction
Shandong Dezhou Xingtai Paper Co., Ltd. is a newly built high-end paperboard production enterprise with domestic leading level established by Shandong Zhaodongfang Pape...[Details]
Smart lighting control systems provide high controllability for various buildings and further enhance the level of green energy. They are the core products of energy conservation and digital techn...[Details]
With the continuous consumption of earth's energy and the scarcity of resources, the harm of greenhouse effect to human beings, and the serious pollution of the atmosphere to the earth, the intern...[Details]
The traditional display screen using 51 single-chip microcomputer to control LED dot matrix has relatively simple functions. If it is to achieve diversified functions, it often takes a lot of time ...[Details]
Experimental tasks
A DS18B20 is used to form a temperature measurement system. The temperature measurement accuracy reaches 0.1 degrees. The temperature range is between -20 degrees and +50 de...[Details]
FPGAs are used in 81% of electronic systems, including many commercial and defense products, and most FPGAs use BGA packaging. The BGA packaging is characterized by small solder balls and small sol...[Details]
At very low temperatures, certain metals and alloys lose their resistance to electric
current
and become
superconductors
. Two parameters that are often measured are the transition ...[Details]
In 2012, more than half of the cars in the European, Japanese and American car markets will be equipped with color displays, navigation systems, satellite communications and other in-vehicle infota...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guangzho...[Details]
1. Overview
At present, an information revolution is in the ascendant around the world, led by microelectronics, computers and communication technologies, and centered on information technolog...[Details]
1 Introduction
With the improvement of people's quality of life, lamps are no longer just basic indoor lighting tools, but also a kind of practical art for architectural decoration. When ther...[Details]
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
