[font=微软雅黑][size=5]I have been tinkering with the Raspberry Pi's WIFI these days, which took some time. Later I found that the Raspberry Pi's Raspbian system has a feature. If the Raspberry Pi's Ether...
I use DSP to make a PFC circuit. What device should I use to sample the voltage and current of the input AC? Is the Hall sensor too large? If I use a resistor directly, the current will be negative. T...
As shown in the figure, the power supply is dual 16. As soon as the TIP41 and TIP42 tubes are connected, they burn out after a while after power is turned on. When TIP41 and TIP42 are removed, the par...
DHCP AUTOIP Static IPAfter DHCP fails, the system will use AUTOIP to configure the IP. I want it to use STATIC static IP after DHCP fails. Question 1: I want to use STATIC static IP after DHCP fails. ...
1. Setting incentives
The input stimulus corresponding to the module under test is set to reg type, the output is set to wire type, and the bidirectional port inout needs to be processed during the te...
In
circuit design,
current
measurement
is widely used, and the main fields are divided into three categories: in measurement,
the electric meter
is used to measure the curre...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
In recent years, the market for mobile/portable devices such as smartphones and laptops has continued to grow rapidly. While these products continue to integrate more new features to enhance the ...[Details]
1. Introduction
Light control circuit plays a vital role in urban street lamps or corridor lighting. With light control circuit, the lights can be automatically turned on and off according to ...[Details]
I. Introduction
In the field of power conversion, isolated converters (forward, flyback, and double-ended) with low output DC voltage all use MOSFET as the rectifier device. Since these devi...[Details]
The data collector of the automatic weather station is generally designed based on a single-chip microcomputer or a PC/104 bus controller. It has the characteristics of good compatibility with PC, low...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
This article will introduce a design method for a distributed control system used in a tracking car, which can perform distributed control of motor modules, sensor modules, and lighting control mod...[Details]
The above is to use MB1404 as a stereo composite signal transmitter. You can use the internal high-frequency amplifier and oscillator or not! According to my experience, I still recommend beginners...[Details]
Cars equipped with xenon headlights are already common on the road. Whether they are standard equipment on high-end cars or embellishments on modified cars, xenon lamps are gradually becoming a sym...[Details]
Leakage current is generated by parasitic resistance paths between the measurement circuit and a nearby voltage source. This current can significantly reduce the accuracy of low current measurement...[Details]
Energy conservation and environmental protection are the main directions of current automotive technology research, and power batteries are the key to electric vehicle technology. Research on powe...[Details]
Current
measurement:
Magnetic balance Hall current
sensor
is used
. The sensor can measure AC from DC to 100kHz.
In automatic measurement and control systems, it is often nec...[Details]
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
