Maximum; 20% to 80% x VDD; Output load (CL) = 4 pF
Worst case; output frequencies ≤ 100 MHz
Worst case; output frequencies > 100 MHz
Output valid time after VDD meets the specified range & STBY# transition
Output load (CL) = 4 pF; 75 MHz
Output load (CL) = 4 pF; 75 MHz; measured over 12 K cycles
6.144
20
49.152
125
7.3728
22.5972
50
133
8
24
60
10
24.576
62.5
12
25
66
12.5
30
66.66
12.288
33
72
14.31818
33.333
74.25
Output Frequency
F
OUT
4
4.096
5
6
15
16
18.432
19.44
36
37.5
40
48
75
80
98.304
100
Contact IDT for additional frequencies
Note: Above specifications are typical at room temperature (25°C ) unless otherwise specified.
* Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 5 years aging at 25°C.
may cause permanent damage to the device. These ratings are
stress specifications only. Functional operation of product at
these or under any condition beyond those listed in the
operating specifications is not implied. Exposure to absolute
maximum rated conditions may affect product reliability.
Item
VDD
STBY#
OUT
Storage Temperature
Solder Reflow Profile
40 sec (max)
250
200
150
100
50
150°C
60-180
sec
(260°C max)
245°C
217°C
s c
/sec
°
/
6
°
C
60-150
sec
a
ma x
4.6 V
-0.5 V to VDD + 0.5 V
-0.5 V to VDD + 0.5 V
-65°C to 150°C
3
°
C/
se
Maximum Absolute Rating
cm
ax
Time
Pin Descriptions
Pin #
1
2
3
4
Output Waveform
Description
T
R
0.8 VDD
T
F
V
OH
Name
STBY#
GND
OUT
2
VDD
Standby Mode
1
(0 = Output Disabled)
Ground
CMOS Output
Power
1. Pulled high internally
2. Weak pull down to GND during STBY# enable and startup
0.5 VDD
0.2 VDD
V
OL
SYM = t
1
/ t
2
t
1
t
2
Ordering Information
3CN11G
Frequency
4 to 133MHz*
4.09600
22.5792
133.000
NSG
E
8
Package
Suffix
NSG
Minimum Order Quantity (MOQ)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Factory Order Increment (FOI)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Package
NSG: 5.0 x 3.2 x 0.85
CVG: 2.5 x 2.0 x 0.85
C:
E:
Temp
0 to 70°C
-20 to 70°C
Shipping
Blank: Tubes
8:
Tape and Reel
CVG
* See frequency table or contact IDT
6024 Silver Creek Valley Road
San Jose, California 95138
Sales
800-345-7015 (inside USA)
+1 408-284-8200 (outside USA)
Fax: 408-284-2775
Technical Support
crystalfreetechsupport@idt.com
+1 408-360-5656
DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT’s sole discretion. All information in this document,
including descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not
guaranteed to perform the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the
suitability of IDT’s products for any particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any
license under intellectual property rights of IDT or any third parties.
IDT’s products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an
IDT product in such a manner does so at their own risk, absent an express, written agreement by IDT.
Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective
After I initialized the serial port 4 in the program, I immediately sent data in query mode, uart4_send(0xAA); It works. But I then added the following contentRCC-APB2ENR|=14; //PORTC clock enableGPIO...
Keysight Technologies DATA Center data to meet your needs~ Download and get a gift! Let's start~Click here to enter the eventEvent time: From now until July 14, 2019
Activity Introduction:
(1) Go to t...
Qorvo's First 39GHz Dual-Channel GAN FEM Enables Next-Generation 5G Wireless NetworksGREENSBORO, N.C. – June 1, 2017 – Qorvo (Nasdaq: QRVO) , a leading provider of innovative RF solutions that connect...
In FPGA design, embedded processor soft cores (such as MicroBlaze, PicoBlaze, etc.) are used to form a programmable system on chip (SOPC). Compared with ASIC, it has better modifiability and maintaina...
On August 24th, Tesla CEO Elon
Musk
revealed information about the upcoming FSD V14, claiming it will outperform human drivers. Tesla FSD lead Ashok stated last year that FSD version 12.5, ...[Details]
Abstract:
With the increasing complexity of smart vehicle electrical and electronic architectures, the full lifecycle management of vehicle electronic control components faces multiple challe...[Details]
To enable real-time monitoring of home security and automatically dial a number for voice prompts or send text messages when an alarm occurs, a GPRS-based embedded telephone alarm system was design...[Details]
Recently,
Xpeng Motors and Xinlian Integrated Circuit jointly announced the mass production of China's first hybrid silicon carbide product.
Designed and developed by Xpeng Motors and joint...[Details]
Capable of providing precise and efficient thermal management for artificial intelligence computing power, intelligent sensing and autonomous driving systems
Shenzhen, ...[Details]
Recently, AstroBo Robot, a subsidiary of Chenxing Automation, launched a new mobile collaborative palletizing product. Leveraging an omnidirectional mobile chassis, an intelligent scheduling system...[Details]
One of the most core components of electric vehicles is the motor. The power supply provides electrical energy to the motor, which converts this electrical energy into mechanical energy, which in t...[Details]
Permanent magnets are essential components in a wide range of household and industrial devices. They are particularly crucial in the renewable energy sector, including electric vehicle motors. Curr...[Details]
1. Ease of Use: The HMI module should be designed to be simple and clear, allowing users to easily operate and configure the energy storage device.
2. Ease of Maintenance: The HMI module should...[Details]
On August 22, according to CNBC's report today, the National Highway Traffic Safety Administration (NHTSA) is launching an investigation into Tesla, and the latter is questioned whether it has fail...[Details]
The 2025 China International Automotive Testing Exhibition will be held at the Shanghai World Expo Exhibition and Convention Center from August 27 to 29, 2025.
Clacton Seafront, UK, ...[Details]
China, August 21, 2025 – STMicroelectronics (NYSE: STM), a world-leading semiconductor company serving a wide range of electronics applications, has published its IFRS 2025 semi-annual financial re...[Details]
Speaking of the problem of vehicle spontaneous combustion, whether it is a pure electric vehicle or a fuel vehicle, there will be incidents of spontaneous combustion. For the same spontaneous combu...[Details]
I recently read an article in the Wall Street Journal titled "We need the right to repair our gadgets" (reference original article: ). The author was very angry about the phenomenon of "planned obs...[Details]
introduction
The rapid adoption of computers has led to a growing number of tasks being performed on them. People from all walks of life, especially programmers and writers, are spending incre...[Details]
stm32/stm8
京公网安备 11010802033920号
EEWORLD
