Maximum; 20% to 80% x VDD; Output load (CL) = 4 pF
Worst case; output frequencies ≤ 100 MHz
Worst case; output frequencies > 100 MHz
Output valid time after VDD meets the specified range & STBY# transition
Output load (CL) = 4 pF; 75 MHz
Output load (CL) = 4 pF; 75 MHz; measured over 12 K cycles
6.144
20
49.152
125
7.3728
22.5972
50
133
8
24
60
10
24.576
62.5
12
25
66
12.5
30
66.66
12.288
33
72
14.31818
33.333
74.25
Output Frequency
F
OUT
4
4.096
5
6
15
16
18.432
19.44
36
37.5
40
48
75
80
98.304
100
Contact IDT for additional frequencies
Note: Above specifications are typical at room temperature (25°C ) unless otherwise specified.
* Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 5 years aging at 25°C.
may cause permanent damage to the device. These ratings are
stress specifications only. Functional operation of product at
these or under any condition beyond those listed in the
operating specifications is not implied. Exposure to absolute
maximum rated conditions may affect product reliability.
Item
VDD
STBY#
OUT
Storage Temperature
Solder Reflow Profile
40 sec (max)
250
200
150
100
50
150°C
60-180
sec
(260°C max)
245°C
217°C
s c
/sec
°
/
6
°
C
60-150
sec
a
ma x
4.6 V
-0.5 V to VDD + 0.5 V
-0.5 V to VDD + 0.5 V
-65°C to 150°C
3
°
C/
se
Maximum Absolute Rating
cm
ax
Time
Pin Descriptions
Pin #
1
2
3
4
Output Waveform
Description
T
R
0.8 VDD
T
F
V
OH
Name
STBY#
GND
OUT
2
VDD
Standby Mode
1
(0 = Output Disabled)
Ground
CMOS Output
Power
1. Pulled high internally
2. Weak pull down to GND during STBY# enable and startup
0.5 VDD
0.2 VDD
V
OL
SYM = t
1
/ t
2
t
1
t
2
Ordering Information
3CN11G
Frequency
4 to 133MHz*
4.09600
22.5792
133.000
NSG
E
8
Package
Suffix
NSG
Minimum Order Quantity (MOQ)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Factory Order Increment (FOI)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Package
NSG: 5.0 x 3.2 x 0.85
CVG: 2.5 x 2.0 x 0.85
C:
E:
Temp
0 to 70°C
-20 to 70°C
Shipping
Blank: Tubes
8:
Tape and Reel
CVG
* See frequency table or contact IDT
6024 Silver Creek Valley Road
San Jose, California 95138
Sales
800-345-7015 (inside USA)
+1 408-284-8200 (outside USA)
Fax: 408-284-2775
Technical Support
crystalfreetechsupport@idt.com
+1 408-360-5656
DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT’s sole discretion. All information in this document,
including descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not
guaranteed to perform the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the
suitability of IDT’s products for any particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any
license under intellectual property rights of IDT or any third parties.
IDT’s products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an
IDT product in such a manner does so at their own risk, absent an express, written agreement by IDT.
Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective
Electronic circuit and EMI/EMC design analysis[ Print ][ Return ]For a good electronic product, in addition to the functions of the product itself, the technical level of circuit design and electromag...
I am a beginner in Linux and now want to transplant Linux into S3C2410. The HyperTerminal and the serial port of Yuanfeng experimental box cannot communicate. The HyperTerminal settings are correct, b...
See the screenshot for the circuit diagram. There are two digital tubes on the right. The function I want to achieve is that after pressing the button, the upper digital tube displays the number of ro...
This design tool is very simple and easy to use. It mainly designs according to various parameters, adjusts size, efficiency, views schematics and design diagrams, looks at replaceable parts, and even...
Without further ado, this is a PCB file of Hisense HI3516D, allegro version. The resource is here:Complete PCB diagram top>>gnd>>signal L3
Six-layer board?
There is no signal line on their power layer...
I need a DA chip for my graduation project. The requirements are: single channel, 8/10 bit accuracy, bipolar voltage output, SPI input interface. I searched online for a long time but couldn't find it...
1. Several nouns
ABI:
The specifications that an executable file must follow in order to run in a specific execution environment;
Separately generated relocatabl...[Details]
With the booming electronics industry, vision systems have become a leader in the electronics automation sector. However, the delicate nature of electronic products often affects product yields due...[Details]
Nios II is a configurable 16-/32-bit RISC processor. Combined with a rich set of peripheral-specific instructions and hardware acceleration units, it provides a highly flexible and powerful SOPC sy...[Details]
On August 24th, media outlets reported, citing sources, that NavInfo, a listed company on the A-share market, is nearing completion in its acquisition of the intelligent driving c...[Details]
Whether it is an electric car or an ordinary fuel car, for the vast majority of car buyers, the final cost of use is what they care about most. For fuel cars, how to save fuel is what drivers care ...[Details]
Zos Automotive Research Institute released the "2025
Smart Cockpit
Tier 1 Research Report (Domestic Edition)."
This report analyzes the operating conditions of more than a dozen ...[Details]
Electric vehicles are now widespread, but they've brought with them a host of problems, the most prominent of which is charging. Small electric vehicles (EVs) are a new form of transportation in a ...[Details]
Based on the commutation technology, thyristor rectifiers are classified into two main types. Line-commutated and force-commutated inverters are commonly used, while other commutated inverters, nam...[Details]
To improve the lateral active safety of intelligent connected vehicles, the identification and definition of unexpected functional safety scenarios for the EPS (Electronic Steering System) ...[Details]
In the field of intelligent driving, regulations are becoming increasingly stringent, and the technical threshold continues to rise. Especially after the traffic accident in March 2025, the Ministr...[Details]
In daily life, when we purchase a transformer, we are faced with the installation and wiring procedures. Generally speaking, large transformers such as power transformers are equipped with speciali...[Details]
introduction
As core electronic components used in vastly different fields, automotive-grade chips and mobile/consumer-grade chips exhibit significant differences in their...[Details]
On August 19, Reuters reported that people familiar with the matter said that Nvidia is developing a new AI chip based on its latest Blackwell architecture for the Chinese market. The performance o...[Details]
With the improvement of China's supporting infrastructure and the accumulation of technology and capital, demand for industrial automation and intelligent applications of machine vision technology ...[Details]
Mathematical functions are very important and are used in many situations such as analog quantity processing and PID control.
(12) Calculate sine value instruction (SIN)
The "Calculate Si...[Details]
Energy Infrastructure?
京公网安备 11010802033920号
EEWORLD
