The chip accepts crystal or clock inputs ranging from
20 to 30MHz, and produces outputs clocks up to
150MHz at 3.3V.
BLOCK DIAGRAM
Phase
Locked
Loop
CLK
XIN
XOUT
XTAL
OSC
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 01/08/02 Page 1
Preliminary
PLL601-15
Low Phase Noise PLL Clock Multiplier
PIN DESCRIPTIONS
Name
CLK
VDD
XIN
XOUT
GND
Number
5
7,6
1
8
2, 3,4
Type
O
P
I
O
P
3.3V Power Supply.
Description
Clock output from VCO. Equals the input frequency times multiplier.
Crystal input to be connected to 20-30MHz fundamental parallel mode crys-
tal (C
L
=15pF). On chip load capacitors: No external capacitor required.
Crystal Connection.
Ground.
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 01/08/02 Page 2
Preliminary
PLL601-15
Low Phase Noise PLL Clock Multiplier
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS
Supply Voltage Range
Input Voltage Range
Output Voltage Range
Soldering Temperature
Storage Temperature
Ambient Operating Temperature
T
S
-65
0
SYMBOL
V
CC
V
I
V
O
MIN.
MAX.
7
V
CC
+
0.5
V
CC
+
0.5
260
150
70
UNITS
V
V
V
°C
°C
°C
-
0.5
-
0.5
-
0.5
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other con-
ditions above the operational limits noted in this specification is not implied.
2. AC Specification
PARAMETERS
Input Frequency
Output Frequency
Output Rise Time
Output Fall Time
Duty Cycle
Period jitter RMS
Accumulated jitter RMS
Phase Noise, relative to carrier, 150Mhz(x5)
Phase Noise, relative to carrier, 150Mhz(x5)
Phase Noise, relative to carrier, 150Mhz(x5)
Phase Noise, relative to carrier, 150Mhz(x5)
At 3.3V
0.8V to 2.0V with no load
2.0V to 0.8V with no load
At VDD/2
With capacitive decoupling
between VDD and GND
With capacitive decoupling
between VDD and GND
100Hz offset, 3.3V
1kHz offset, 3.3V
10kHz offset, 3.3V
100kHz offset, 3.3V
45
50
6.4
9.4
-103
-126
-133
-128
CONDITIONS
MIN.
20
TYP.
MAX.
30
150
1.5
1.5
55
UNITS
MHz
MHz
ns
ns
%
ps
ps
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 01/08/02 Page 3
Preliminary
PLL601-15
Low Phase Noise PLL Clock Multiplier
3. DC Specification
PARAMETERS
Operating Voltage
Input High Voltage
Input Low Voltage
Input High Voltage
Input Low Voltage
Output High Voltage
Output Low Voltage
Output High Voltage At
CMOS Level
Operating Supply Current
Short-circuit Current
SYMBOL
VDD
V
IH
V
IL
V
IH
V
IL
V
OH
V
OL
V
OH
I
DD
I
S
CONDITIONS
MIN.
3.135
2
TYP.
MAX.
3.465
0.8
UNITS
V
V
V
V
V
V
V
V
For XIN pin
For XIN pin
I
OH
= -25mA
I
OL
= 25mA
I
OH
= -8mA
No Load
(VDD/2)
+
1
2.4
VDD/2
VDD/2
(VDD/2)
−
1
0.4
VDD-0.4
35
±120
mA
mA
4. Crystal Specifications
PARAMETERS
Crystal Resonator Frequency
Crystal Loading Capacitance
Rating
SYMBOL
F
XIN
C
L
(xtal)
CONDITIONS
Parallel Fundamental Mode
MIN.
20
TYP.
MAX.
30
UNITS
MHz
pF
15
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 01/08/02 Page 4
Preliminary
PLL601-15
Low Phase Noise PLL Clock Multiplier
PACKAGE INFORMATION
8 PIN ( dimensions in mm )
Narrow SOIC
Symbol
A
A1
B
C
D
E
H
L
e
Min.
1.47
0.10
0.33
0.19
4.80
3.80
5.80
0.38
Max.
1.73
0.25
0.51
0.25
4.95
4.00
6.20
1.27
1.27 BSC
Min.
-
0.05
0.19
0.09
2.90
4.30
6.20
0.45
TSSOP
Max.
1.20
0.15
0.30
0.20
3.10
4.50
6.60
0.75
0.65 BSC
A1
B
e
C
L
A
D
E
H
ORDERING INFORMATION
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PART NUMBER
PLL601-15 X C
PART NUMBER
TEMPERATURATURE
C=COMMERCIAL
M=MILITARY
I=INDUSTRAL
PACKAGE TYPE
S=SOIC, O=TSSOP
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information fur-
nished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY:
PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the ex-
press written approval of the President of PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Hello everyone! We are currently developing a membership management system that requires a radio frequency reader to read and write contactless IC cards. Multiple card machines are connected in parall...
I am working on a project now. The development tool is EVC, the PDA system is WCE.NET 5.0, and the PDA has a CDMA wireless communication module. I want to implement remote access to the ACCESS databas...
MINI_STM32 development board (minimum system core board) Mainboard configuration: 1. CPU: STM32F103RBT6, ARM Cortex-M3 core, 128kB Flash, 20KB RAM, maximum working clock 72MHz, 64 pins 2. USB interfac...
As shown in the figure below: DISCTR1 is the control input terminal, OE1 is the output terminal, and the function is to control the high and low levels of OE1 output. When disctr1 is at a low level of...
With the rapid development of science and technology, especially the widespread application of digital technology and various ultra-large-scale integrated circuits, electronic equipment, especially...[Details]
0 Introduction
With the development of my country's economy, the number of motor vehicles continues to increase. The growth of existing roads and other hardware facilities can no longer meet t...[Details]
12v Lead Acid batteries used in trucks, cars, RVs and uninterruptible power supplies are usually rated at 12V. This circuit monitors the battery, the charge and discharge curves, gives the cu...[Details]
introduction
MAX6636 is a multi-channel precision temperature monitor that can not only monitor local temperature, but also connect up to 6 diodes externally. Each channel has a programmable...[Details]
Investment in
the
medical device
industry has been on the rise in recent years. In the past two years, venture capital for medical devices has almost doubled, reaching $4 billion in 2007. Fr...[Details]
Printed circuit boards ( PCBs
)
are used in most electrical products
. If a PCB has low
insulation resistance
(IR), the performance of the circuits on the PCB will be greatly reduced...[Details]
Recently, news came from the certification department that the photovoltaic grid-connected inverter of Samil New Energy Co., Ltd. (hereinafter referred to as "Samil New Energy") has once again obta...[Details]
1. Proposal of
reconfigurable
measurement and control system
The measurement and control system generally refers to a system based on
computers
to realize data acquisition a...[Details]
With the rapid development of cities and the improvement of citizens' living standards, the number of various vehicles in cities is growing, and the demand for parking spaces in major commercial an...[Details]
Key Points
1. Now, in addition to high-end smartphones and tablets, users also expect to use touch screens in other applications, and they are gradually appearing in cars and instruments.
...[Details]
introduction
Steam turbines are driven by high-temperature and high-pressure steam generated by boilers to run at high speed. They are key power equipment in thermal power plants. The emergenc...[Details]
A stepper motor is an electromagnetic mechanical device that converts an electrical pulse signal into an angular displacement or a linear displacement. The stability and reliability of a stepper mo...[Details]
As the global LED market demand continues to increase, my country's LED industry will face huge opportunities in the future. However, the core LED technology and patents are basically monopolized b...[Details]
Electric bicycles have long been a means of transportation for lower-income groups due to their affordability. The largest concentrated expense in the use of electric vehicles is the cost of replac...[Details]
The power consumption of a switching power supply includes fixed losses caused by parasitic resistances such as semiconductor switches, magnetic components, and wiring, as well as switching losses ...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
