-
1. Development Environment 1. Applicable chips: All STM32F4 chips 2. Firmware library: STM32F4xx_DSP_StdPeriph_Lib_V1.8.0 3，IDE：MDK517 2. Driver source code Delay.h File /**...[Details]
-
In the actual project development process, it is common to encounter modifications to the hardware circuit, and then the modified part requires the modification of the driver. Thinking about the comi...[Details]
-
0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]
-
1. Initial understanding of FSMC: FSMC consists of 4 modules: (1) AHB interface (including FSMC configuration register) (2) NOR flash memory and PSRAM controller (when driving LCD, LCD is like a PSRA...[Details]
-
Overview
Lightning is a strong discharge phenomenon that occurs between thunderstorm clouds and between thunderstorm clouds and the earth due to severe convective weather. Lightning is gen...[Details]
-
According to the description provided in the official manual of ST, it is not difficult to see that the ADC analog watchdog is actually that the user can set an upper and lower limit of the AD value...[Details]
-
LiDAR: Autonomous driving from the perspective of optoelectronic technology LiDAR and competing sensor technologies (camera, radar, and ultrasonic) intensify the need for sensor fusion and the need...[Details]
-
ADI has established long-term good relationships with car manufacturers and Tier 1 component suppliers. Based on its previous long-term successful cooperation with new energy vehicles and suppliers a...[Details]
-
Use the STM32 timer input capture module to control 3-way ultrasonic sensors. The ultrasonic sensor used this time is the common HC-SR04, which is often used in the obstacle avoidance system of smal...[Details]
-
The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]
-
MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]
-
1. Analysis of the main causes of AVR damage: The AVR circuit consists of three parts: the rectifier main circuit, the voltage detection circuit, and the comparison control circuit. Excluding the...[Details]
-
#include iom16v.h #include macros.h #include "key.h" #include "1602.h" #include "delay.h" unsigned char display ={0,0,0}; //display data void main(void) { unsigned char Key; LCD_init(); ...[Details]
-
The top row of pins is the row, and the bottom row of pins is the column. The row is the LED anode. Each row and column is controlled by four 74HC573, each controlling 8 pins. At the sa...[Details]
-
#include "IRRemote.h" void main(void) { //初始化 Initialize(); //Infinite loopwhile (1) { unsigned int transmit; //Initialize va...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
