EEWORLDEEWORLDEEWORLD

Part Number

Search

NEV0.47M63

Description
ALUMINUM ELECTROLYTIC 6.3V to 100V
File Size26KB,3 Pages
ManufacturerNTE
Websitehttp://www.nteinc.com
Download Datasheet View All

NEV0.47M63 Overview

ALUMINUM ELECTROLYTIC 6.3V to 100V

ALUMINUM ELECTROLYTIC 6.3V to 100V
NEV, NEH SERIES
SUBMINIATURE
(NEV: Radial Lead, NEH: Axial Leads)
The NEV and NEH series subminiature aluminum electrolytic ca-
pacitors are especially suitable for applications requiring high ca-
pacitance, low cost, and very small size. In fact, you’ll find these
capacitors in some of the most demanding applications, from
precision medical electronics and automobiles to the newest
personal computers and disk drives.
They operate over a broad temperature range and are available
in either blister pack or bulk.
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL - STD 202, Method 208
Marking:
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petroleum
ether, propanol and/or commercial detergents. Halo-
genated hydrocarbon cleaning agents such as Freon
(MF, TF, or TC), trichloroethylene, trichloroethane, or
methylchloride are not recommended as they may
damage the capacitor.
RATINGS
Capacitance Range:
0.1µf to 22,000µf
Tolerance:
±20%
Voltage Range:
6.3V to 100V
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
- 40°C to +85°C ( - 40°F to +185°F)
Leakage Current:
I
0.01CV + 3µA (measured after
3 minutes of applied voltage)
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
Capacitance Tolerance (M):
±20%
measured at +20°C (+68°F), 120H
Z
Dissipation Factor:
measured at +20°C (+68°F),120H
Z
Rated Voltage
0.1µf to 1000µf
1000µf to 22,000µf
6.3
0.24
10
0.2
16
0.17
25
0.15
35
0.12
50 - 80
0.10
100
0.08
CASE SIZE AND DIMENSIONS:
NEV SERIES
Insulating
Sleeve
18.0 Min
A
±0.5

L
L’
5.0 Min
L’ = L + 1.0 Max at D Ø
8.0
D’ Ø
L’ = L + 2.0 Max at D Ø
10.0
D’ Ø = D Ø + 0.5 Max
Values above plus 0.02 for each 1000µf
Impedance Ratio at Low Temperature:
120H
Z
Comparison Z WV
Z @ - 25°C ( - 13°F)/
Z @ +20°C (+68°F)
Z @ - 40°C ( - 40°F)/
Z @ +20°C (+68°F)
6.3
4
8
10
3
6
16
2
4
25
2
4
35
2
4
50 - 100
NEH SERIES
(Insulating Bar = Negative)
L
Insulating
Sleeve
2
4

2.3 Max
Surge Voltage:
DC Rated Voltage
Surge Voltage
6.3
8
10
13
16
20
25
32
35
44
50
63
63
79
100
125
D’ Ø = D Ø + 0.5 Max
35.0 Min
L’
35.0 Min
D’ Ø
Load Life:
1000
±12Hrs
@ +85°C (+185°F),
at rated voltage
Leakage Current: Within values specified above
Dissipation Factor: Within
±150%
of specified value
Capacitance Change Max: See Table
Rated Voltage
6.3V to 16V
25V to 100V
Capacitance Change Max
Within
±30%
of the initial value
Within
±20%
of the initial value
L’ = L + 1.0 Max at D Ø
8.0
L’ = L + 2.0 Max at D Ø
10.0
ORDERING INFORMATION
NEV
Series
Capacitance
Tolerance
Voltage
47
M
50
Shelf Life:
1000 Hrs @ +85°C (+185°F),
no voltage applied
Leakage Current: Within
±200%
of specified value
Dissipation Factor: Within
±150%
of specified value
Capacitance Change Max: Within
±20%
of initial value
2
NTE Electronics, Inc.
D
Voice (800) 631 - 1250 (973) 748 - 5089
D
FAX (973) 748 - 6224
D
http://www.nteinc.com
32 most popular CPLD-FPGA forums
1. OPENCORES.ORG There are many good PLD cores here, and the 8051 core can be found there. After entering, select project or go to http://www.opencores.org/browse.cgi/by_category. For those who want t...
songbo FPGA/CPLD
TMS320F28335 project development record 4_28335 startup mode (serial port flash burning)
// $Boot_Table: // // GPIO87 GPIO86 GPIO85 GPIO84 // XA15 XA14 XA13 XA12 // PU PU PU PU // ============================================ // 1 1 1 1 Jump to Flash >PS: I once got the error prompt of fai...
风雨也无晴 Microcontroller MCU
How does WinCE emulator adjust the memory size ()
There are two things I don't understand: 1. The default memory size is 128m, but when I open the simulator's memory manager, the total memory I can see is about 60-70m. Does the system occupy the rest...
kangtc86 Embedded System
Using 18f2550 as PWM sine generator
[i=s]This post was last edited by martymak on 2021-9-1 11:33[/i]有高人用过18F2550 for PWM sine generator ,可否指教一下,或者給我一個例子?...
martymak Microchip MCU
TI CCS MAP File Description
MAP file is a mapping file for all programs, data and IO space used by DSP generated after CCS software is compiled.1. Generation methodThere are two main methods to generate MAP file. One is to gener...
火辣西米秀 Microcontroller MCU
MicroPython has been upgraded to 1.9, and the firmware of various development boards has been gradually updated.
Last week, MicroPython was upgraded to V1.9, so we started to update the firmware of various development boards to facilitate everyone's experience and testing. [list] [*][url=https://github.com/shaoz...
dcexpert MicroPython Open Source section

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 713  1547  1924  1958  26  15  32  39  40  1 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号